Dorman 936-192 Drive Shaft - Rear

Dorman 936-192 Rear Drive Shaft

This Dorman drive shaft assembly is built for rear driveline service on select Chrysler Aspen and Dodge Durango models. It arrives pre-balanced and ready to install, with new yokes, tubes, CV joints, and universal joints for a complete replacement solution.

Key Features

• Complete rear drive shaft assembly for driveline replacement
• Pre-balanced for smoother operation after installation
• Steel shaft construction with a 3.25 in diameter
• 62.5 in drive shaft length and 0.065 in wall thickness
• Slip yoke included
• 100% new yokes, tubes, CV joints, and universal joints per manufacturer description
• Part number 936-192 for easy identification

Detailed Description

Dorman 936-192 is a rear drive shaft assembly engineered for direct replacement in 2007-2009 Chrysler Aspen and 2004-2009 Dodge Durango applications. The steel shaft is pre-balanced and built with a fixed overall length, making it a practical choice when replacing a worn or damaged driveline component. This part number 936-192 also cross-references Cardone Reman 65-3014 for the same application.

For buyers searching for a rear drive shaft for Chrysler Aspen or a Dodge Durango rear driveshaft replacement, this assembly provides the core driveline components needed for service work. The slip yoke is included, while CV joints are not included as a separate attribute listing, so review the application details carefully before ordering.

What It Helps Address

• Vibration from a worn or out-of-balance rear driveshaft
• Clunking or driveline noise during acceleration or deceleration
• Excess play from worn yokes or universal joints
• Damage to the original shaft tube or driveline assembly
• Service needs on rear driveline systems for Aspen and Durango models

Installation Notes and Tips

Verify rear-position fitment before installation. Confirm the vehicle application against the listed years for 2007-2009 Chrysler Aspen, rear, and 2004-2009 Dodge Durango, rear. Measure the existing shaft length and compare it to the 62.5 in specification, and inspect mating components for wear before installing the replacement assembly. Because this is a fixed-length shaft, proper application matching is important for correct driveline alignment.

Quality Assurance

Dorman supplies this assembly as a complete replacement driveline component with new major wear parts and pre-balanced construction. The part number 936-192 is intended for direct-fit service on the listed rear applications and is built to meet regular-grade replacement needs.