Dorman 936-547 Drive Shaft - Rear

Rear Drive Shaft for Tacoma

This Dorman rear drive shaft is built for 1995-2004 Toyota Tacoma applications and addresses a common service issue found in the original shaft design. Part number 936-547 replaces the factory unit with a steel shaft that uses serviceable universal joints for easier maintenance.

• Fits 1995-2004 Toyota Tacoma, rear
• Steel shaft construction
• 3-inch shaft diameter
• 60-inch drive shaft length
• 0.065-inch wall thickness
• Slip yoke included
• OE FIX design for serviceable U-joints
• Cross-reference: 3711004040

Built for Serviceable Maintenance

Dorman 936-547 is a rear drive shaft for Toyota Tacoma trucks that replaces the original shaft on specific vehicles where the universal joints were permanently staked in place. By making the U-joints serviceable, this OE FIX design simplifies future driveline maintenance and helps reduce the need to replace the entire shaft for routine joint service. The steel construction, 3-inch diameter, and 60-inch overall length support a direct-fit replacement for the listed rear application.

Common Issues This Part Can Address

• Worn or noisy rear drive shaft U-joints
• Difficulty servicing permanently staked factory universal joints
• Driveline vibration related to a damaged shaft assembly
• Corrosion or fatigue in the original steel shaft
• Need for a replacement rear driveshaft on a Toyota Tacoma

Installation Notes and Tips

Verify rear application fitment before installation on your Toyota Tacoma. Confirm shaft length, slip yoke configuration, and driveline condition prior to removal of the original part. Inspect related driveline components, including mounting points and companion hardware, for wear or damage before installing Dorman 936-547.

Quality Assurance

Dorman OE FIX parts are engineered to address known service limitations in original equipment designs while maintaining application-specific fitment for the listed Toyota Tacoma rear drive shaft use.