Dorman 962-245 Engine Camshaft Position Sensor

Dorman 962-245 Camshaft Position Sensor

Dorman 962-245 is an engine camshaft position sensor built to match the fit and function of the original part. It helps restore proper signal input to the engine control unit when the factory sensor has failed from heat or internal component damage. Compatible With Ford F-150, F-350, F-250 Super Duty, and E-350 Super Duty applications across the listed model years.

Key Features

• Engine camshaft position sensor for ignition and engine management systems
• Standard replacement grade for OE-style fit and function
• Black housing with a rectangular 1-connector design
• 3-terminal, male connector with female terminals
• 12-volt electrical specification
• Mounting bracket included
• Wiring harness, wire lead, and mounting hardware are not included

Detailed Description

This Dorman camshaft position sensor, part number 962-245, is designed for direct replacement use where the original sensor has failed and the engine control unit is no longer receiving accurate camshaft position data. The sensor uses a rectangular connector layout and standard replacement construction to align with the original installation point and electrical interface. It cross-references Standard Ignition PC852 for the same application. Fits 2010-2014 Ford F-150, 2011-2016 Ford F-350, 2011-2020 Ford F-250 Super Duty, and 2017-2019 Ford E-350 Super Duty.

Common Issues This Sensor May Address

• Check engine light related to camshaft position signal faults
• Hard starting or extended crank conditions tied to sensor failure
• Rough idle caused by incorrect camshaft timing input
• Intermittent stalling or hesitation from unstable sensor readings
• Engine control unit input errors after heat-related sensor damage

Installation Notes and Tips

Verify connector shape, terminal count, and mounting location before installation. Confirm the vehicle application against the listed Ford F-150, Ford F-350, Ford F-250 Super Duty, or Ford E-350 Super Duty fitment before replacing the sensor. Inspect the connector and surrounding wiring for heat damage or corrosion, and clear diagnostic trouble codes after installation if required by the repair procedure.

Quality Assurance

Dorman manufactures this sensor as a standard replacement part intended to match original fit and function for the listed applications. Part number 962-245 is built for direct replacement use in Ford camshaft position sensor service.