Dorman 986-142 Drive Shaft - Rear

Rear Driveshaft for 2010 Toyota Tundra

Dorman 986-142 is a complete rear drive shaft assembly for the 2010 Toyota Tundra. It arrives pre-balanced and built with new yokes, tubes, universal joints, and a ready-to-install layout for a direct driveline replacement.

Key Features

• Fits 2010 Toyota Tundra, rear
• Complete drive shaft assembly for driveline service
• Pre-balanced for installation readiness
• 100% new yokes, tubes, and universal joints
• Aluminum shaft construction
• Flange-to-flange end design
• Overall length adjustable for application fitment
• Part number 986-142

Product Details

This Dorman drive shaft is built for rear driveline replacement on the 2010 Toyota Tundra. The aluminum shaft measures 63 inches in drive shaft length with a 61.5-inch compressed length, a 5-inch shaft diameter, and 0.125-inch wall thickness. It uses flange ends on both sides and includes universal joints, while CV joints are not included. The assembly is not greaseable and does not use a slip yoke.

Part number 986-142 cross-references Toyota OE number 371100C180 for the same application. For buyers searching for a 2010 Toyota Tundra rear drive shaft assembly, this unit provides the core driveline components needed for replacement without rebuilding the original shaft.

Common Issues This Part Can Address

• Vibration from a worn or out-of-balance rear driveshaft
• Noise caused by worn universal joints
• Driveline play from damaged yokes or tubes
• Service needs after shaft damage or corrosion
• Replacement of a failed rear drive shaft on a 2010 Toyota Tundra

Installation Notes and Tips

Verify flange-to-flange measurements, compressed length, and overall driveline configuration before installation. Confirm rear position fitment on the 2010 Toyota Tundra and inspect mating surfaces, flange condition, and related driveline hardware during service. Because the shaft is pre-balanced, avoid altering the assembly before installation.

Quality Assurance

Dorman manufactures this drive shaft as a complete replacement assembly with new core components for driveline service. The pre-balanced design supports straightforward installation on the specified Toyota Tundra application.