Dorman 986-149 Drive Shaft - Rear

Dorman 986-149 Rear Driveshaft for Toyota Sequoia

The Dorman 986-149 is a complete rear drive shaft assembly for the Toyota Sequoia. It arrives pre-balanced and ready to install, with new yokes, tubes, universal joints, and a slip yoke for a direct replacement approach on 2008-2021 Toyota Sequoia rear applications.

Key Features

• Complete rear drive shaft assembly for Toyota Sequoia
• Pre-balanced for installation readiness
• Steel shaft construction with 3.5 in diameter and 0.083 in wall thickness
• Flange-to-flange end configuration
• Greaseable design with universal joints included
• Overall length adjustable for fitment alignment
• Compressed length: 55 in; drive shaft length: 56.5 in

Product Details

Built for rear driveline service, this Dorman drive shaft replacement is specified for 2008-2021 Toyota Sequoia models with the steel conversion shaft configuration. The assembly uses steel shaft material, includes universal joints, and features a slip yoke to support proper driveline connection. Dorman 986-149 is a practical replacement when the original shaft is worn, damaged, or out of balance, and it cross-references 371100C153 for the same application.

Common Problems This Part Can Address

• Driveline vibration from a worn or unbalanced shaft
• Clunking or driveline noise from failed joints
• Excess play caused by worn yokes or shaft components
• Corrosion or structural damage to the original driveshaft
• Fitment issues on rear Toyota Sequoia steel conversion shaft applications

Installation Notes and Tips

Verify rear fitment before installation and confirm flange-to-flange configuration, shaft length, and overall driveline measurements against the original part. The shaft is adjustable in overall length, which helps with alignment during replacement. Because this assembly is greaseable, follow standard driveline service procedures and lubricate service points according to vehicle maintenance requirements. Dorman 986-149 is listed for rear installation on Toyota Sequoia models only.

Quality Assurance

Dorman supplies this driveshaft as a complete replacement assembly with new yokes, tubes, and joints to support a straightforward repair. The pre-balanced construction helps reduce the need for additional balancing steps during installation.

Fitment

• Fits 2008-2021 Toyota Sequoia, rear, Steel Conversion Shaft