Dorman 986-432 Drive Shaft - Rear

Rear Drive Shaft Assembly for Audi and Volkswagen

Dorman 986-432 is a complete rear drive shaft assembly for select Audi and Volkswagen applications. It is pre-balanced and built with new yokes, tubes, CV joints, and universal joints to simplify replacement on the driveline.

• Pre-balanced rear drive shaft assembly
• 100% new yokes, tubes, constant velocity joints, and universal joints
• Steel shaft construction
• Bolt-on end 1 and bolt-on end 2
• 83.75 in. compressed length
• 2.5 in. shaft diameter with 0.083 in. wall thickness
• Standard replacement grade
• CV joints included; universal joints not included
• Slip yoke: no

Detailed Product Overview

This Dorman drive shaft assembly is built for rear driveline service on the Audi A3 Quattro, Volkswagen Golf R, and Volkswagen R32. The 986-432 replacement shaft arrives as a complete assembly, helping reduce the time needed to source separate driveline components. Its steel tube construction, bolt-on ends, and fixed overall length make it a direct-fit solution for vehicles that require an 83.75-inch rear driveshaft.

For shoppers searching for a rear drive shaft for 2006-2013 Audi A3 Quattro, a Volkswagen Golf R rear driveshaft, or a Volkswagen R32 driveline replacement, Dorman 986-432 provides the key dimensions and joint configuration needed for the application. This part cross-references OE numbers 1K0521101E and 1K0521101J for the same application.

Common Problems This Part Can Address

• Driveline vibration from a worn or out-of-balance shaft
• Noise from deteriorated CV joints or joint wear
• Clunking or driveline lash caused by shaft component wear
• Corrosion or fatigue in the original rear drive shaft assembly
• Fitment issues when replacing a damaged OE rear driveshaft

Installation Notes and Tips

Verify the vehicle’s rear driveline configuration, compressed length, and bolt-on end style before installation. Confirm that the replacement shaft matches the original 83.75 in. length and 2.5 in. diameter, and inspect mounting points, flanges, and surrounding driveline components for wear before fitting the new assembly. Because this unit is pre-balanced, avoid altering the shaft or joints during installation.

Quality Assurance

Dorman supplies this drive shaft as a standard replacement assembly with new major wear components already installed. The design focuses on restoring proper driveline function with the correct length, joint type, and steel construction for the listed Audi A3 Quattro, Volkswagen Golf R, and Volkswagen R32 rear applications.