Dorman 986-450 Drive Shaft - Rear

Dorman 986-450 Rear Driveshaft for Camaro

Dorman 986-450 is a complete rear drive shaft assembly for select Chevrolet Camaro applications. It arrives pre-balanced and built with new yokes, steel tubing, and universal joints to simplify replacement on the rear driveline.

Key Features

• Complete drive shaft assembly for rear installation
• Pre-balanced for direct replacement service
• 100% new yokes, tubes, and universal joints
• Steel shaft construction with 2.5 in. diameter
• 53.625 in. compressed length and 0.083 in. wall thickness
• Triprong end 1 and triprong end 2 configuration
• Universal joints included; CV joints not included
• Non-greaseable design with no slip yoke

Detailed Description

This Dorman drive shaft is built for rear-drive Chevrolet Camaro models and is engineered as a direct replacement for the original driveline component. The assembly measures 53.625 inches in compressed length and uses steel construction for the shaft body. With new yokes, tubes, and universal joints already installed, part number 986-450 reduces the need to source separate driveline pieces during service. It cross-references 22999284 for the same application. Compatible With 2016-2018 Chevrolet Camaro, rear, and 2019 Chevrolet Camaro, rear, ID ABJ8, ABLB. Compatible With 2020-2024 Chevrolet Camaro, rear. For shoppers searching for a rear driveshaft for Chevrolet Camaro 2016-2024, this assembly provides the key dimensions and end configurations needed for proper replacement.

Common Problems This Part Can Address

• Vibration from a worn or out-of-balance driveshaft
• Clunking or driveline noise from worn universal joints
• Damage to the original shaft tubes or yokes
• Service issues caused by a bent or fatigued rear driveshaft
• Replacement needs after driveline wear on Camaro rear applications

Installation Notes and Tips

Verify the vehicle’s rear driveline configuration before ordering, especially on 2019 Camaro models with ID ABJ8 or ABLB. Confirm compressed length, end type, and shaft diameter against the original part to ensure proper alignment and fit. Because this assembly is pre-balanced, it should be installed as a complete unit rather than disassembled for component-level repair.

Quality Assurance

Dorman manufactures this replacement driveshaft as a complete assembly with new structural and joint components for service-ready installation. Part number 986-450 is built to match the listed Camaro rear applications and support a straightforward driveline replacement.