Dorman 986-545 Drive Shaft - Rear

Dorman 986-545 Drive Shaft for BMW 228i xDrive

Replace a worn driveline component with this Dorman drive shaft assembly, built for direct replacement service on the rear of the 2015 BMW 228i xDrive. Part number 986-545 arrives pre-balanced and assembled with new yokes, tubes, CV joints, and universal joints for a straightforward driveline repair.

Key Features

• Fits 2015 BMW 228i xDrive, rear, to 7/15
• Complete drive shaft assembly for standard replacement service
• Pre-balanced for installation readiness
• 100% new yokes, tubes, constant velocity joints, and universal joints
• Steel shaft construction with 2.5 in shaft diameter
• 44 in compressed length and 0.083 in wall thickness
• Bolt-on end 1 and bolt-on end 2 design
• Slip yoke not included

Detailed Description

Dorman 986-545 is a rear drive shaft assembly for the 2015 BMW 228i xDrive. It is engineered as a standard replacement driveline component and is supplied pre-balanced to reduce the need for additional setup before installation. The steel shaft uses bolt-on ends, measures 44 inches in compressed length, and features a 2.5-inch diameter with 0.083-inch wall thickness. This assembly is built with new yokes, tubes, CV joints, and universal joints to restore driveline function on the BMW 228i xDrive rear application. If you are searching for a BMW 228i xDrive rear drive shaft replacement, Dorman 986-545 provides a direct-fit service part for this specific vehicle and position.

This part cross-references BMW OE numbers 26108602895 and 26108678475 for the same application.

Common Problems This Part Can Address

• Driveline vibration from a worn or out-of-balance shaft
• Clunking or knocking from worn universal joints
• Binding or rough rotation caused by damaged CV joints
• Noise from fatigued yokes or tube wear
• Loss of driveline smoothness in the rear shaft assembly

Installation Notes and Tips

Confirm rear-position fitment before ordering and verify the vehicle build date, since this application is listed for 2015 BMW 228i xDrive models built to 7/15. Inspect flange surfaces, mounting points, and surrounding driveline components before installation. Because this assembly is bolt-on at both ends, proper alignment and torque verification are important for a clean install and balanced operation.

Quality Assurance

Dorman supplies this drive shaft as a complete replacement assembly with new internal and external wear components, including yokes, tubes, CV joints, and universal joints. The pre-balanced design supports consistent driveline operation after installation.