Dorman 986-565 Drive Shaft - Rear

Dorman 986-565 Rear Drive Shaft

Dorman 986-565 is a complete rear drive shaft assembly for select BMW xDrive applications. It is pre-balanced and built with new yokes, tubes, universal joints, and CV joints excluded, giving you a direct replacement option for driveline service on BMW 320i xDrive, 328i xDrive, and 428i xDrive models.

Key Features

• Complete drive shaft assembly for rear driveline replacement
• Pre-balanced for installation readiness
• 100% new yokes and tubes
• Steel shaft construction with a 2.5 in diameter
• 48.875 in compressed length and 0.083 in wall thickness
• Bolt-on end 1 and bolt-on end 2 for straightforward fitment
• Universal joints included; CV joints not included
• Slip yoke not included

Detailed Description

This Dorman drive shaft, part number 986-565, is a standard replacement assembly engineered for rear-position BMW xDrive driveline service. It is built from steel and supplied as a pre-balanced unit to reduce the need for additional setup before installation. The assembly uses bolt-on connections at both ends and measures 48.875 inches in compressed length, making it a direct-fit solution for the listed BMW 320i xDrive, 328i xDrive, and 428i xDrive applications. This part cross-references BMW OE number 26108642909 for the same application.

Compatible With 2017-2018 BMW 320i xDrive, rear; 2016 BMW 320i xDrive, rear from 7/15; 2016 BMW 328i xDrive, rear from 7/15; 2016 BMW 428i xDrive, rear from 7/15; and 2016 BMW 428i xDrive Gran Coupe, rear from 7/15. If you are replacing a worn BMW drive shaft on an xDrive vehicle, Dorman 986-565 provides the core dimensions and end types needed for the listed rear driveline applications.

What It Helps Fix

• Driveline vibration caused by a worn or out-of-balance shaft
• Clunking or driveline noise from worn universal joints
• Loss of smooth power transfer through the rear driveline
• Service issues related to damaged yokes or tube wear
• Replacement needs after driveline component failure on BMW xDrive models

Installation Notes and Tips

Verify rear-position fitment, compressed length, and bolt-on end configuration before installation. Confirm the vehicle build date for 2016 applications noted as from 7/15. Inspect mating driveline components, flange surfaces, and fasteners for wear or damage before installing the replacement shaft. Because this assembly is pre-balanced, handle it carefully during installation to avoid affecting balance.

Quality Assurance

Dorman supplies this drive shaft as a standard replacement assembly with new yokes, tubes, and universal joints included in the design. The pre-balanced construction supports consistent driveline operation for the specified BMW applications.