Dorman 986-682 Drive Shaft - Rear

Dorman 986-682 Rear Drive Shaft for Titan XD

Dorman 986-682 is a complete rear drive shaft assembly for the 2017-2019 Nissan TITAN XD. It arrives pre-balanced and ready to install, with new yokes, tubes, constant velocity joints, and universal joints already assembled for a direct driveline replacement.

Key Features

• Fits 2017-2019 Nissan TITAN XD, rear
• Complete drive shaft assembly for driveline service
• Pre-balanced for smoother operation after installation
• 100% new yokes, tubes, CV joints, and universal joints
• Steel shaft construction with a 3.5 in. shaft diameter
• Pre-greased with grease fitting included
• Bolt-on end design at both ends
• Phased at 0 degrees
• Compressed length: 68.375 in.; drive shaft length: 69.5 in.
• Standard replacement grade

Detailed Description

This Dorman drive shaft is built as a complete replacement for rear driveline service on the Nissan TITAN XD. The assembly uses steel construction, a slip yoke, and new universal joints to replace worn driveline components without rebuilding the original shaft. Part number 986-682 is also cross-referenced to Nissan 37300EZ00A for the same application.

For shoppers searching for a rear drive shaft for 2017-2019 Nissan TITAN XD, Dorman 986-682 provides a direct-fit solution with the dimensions and end types needed for a proper replacement. The shaft is pre-greased, includes a grease fitting, and is configured as a multi-piece shaft with overall length adjustment.

What It Helps Fix

• Driveline vibration from a worn or out-of-balance shaft
• Clunking or driveline noise from worn universal joints
• Binding or rough operation from damaged yokes
• Loss of smooth power transfer to the rear axle
• Service issues caused by a fatigued or corroded drive shaft

Installation Notes and Tips

Confirm rear-position fitment before ordering: this part fits 2017-2019 Nissan TITAN XD, rear. Verify compressed length, flange-to-flange length, and slip travel against the original shaft before installation. Because the assembly is pre-balanced and phased at 0 degrees, it should be installed in the correct orientation to maintain driveline smoothness. Inspect companion flanges, mounting points, and surrounding driveline components during replacement.

Quality Assurance

Dorman supplies this drive shaft as a standard replacement assembly built with new components for service-ready installation. The design focuses on restoring driveline function with pre-balanced construction and new joints, yokes, and tubing.