Dorman 986-755 Drive Shaft - Rear

Dorman 986-755 Rear Drive Shaft for Rogue

Restore driveline performance with the Dorman 986-755 drive shaft assembly for the rear of select Nissan Rogue models. This complete assembly is pre-balanced and built with new yokes, tubes, CV joints, and universal joints for a direct replacement approach on 2017-2019 Nissan Rogue rear applications.

Key Features

• Complete drive shaft assembly for rear fitment
• Pre-balanced for installation readiness
• 100% new yokes, tubes, constant velocity joints, and universal joints
• Steel shaft construction with a 2.5 in shaft diameter
• Standard replacement grade for OE-style service
• Phased design with 0 phase degrees
• Compressed length: 87 in; drive shaft length: 88 in
• End 1 and End 2 type: bolt on

Detailed Description

Dorman 986-755 is a rear drive shaft assembly engineered for 2017-2019 Nissan Rogue models. It uses a steel shaft with a 0.65 in wall thickness, pre-greased joints, and no slip yoke, helping simplify replacement when the original driveline assembly is worn or damaged. The assembly is configured with bolt-on ends and includes CV joints and universal joints already installed. This part cross-references Monroe Shocks & Struts (e.g., 370004BB1A) for the same application.

Fits 2017-2019 Nissan Rogue, rear. The Dorman 986-755 is a direct-fit driveline service part for rear-drive shaft replacement on these Rogue model years.

Common Repair Reasons

• Vibration from a worn or out-of-balance rear driveshaft
• Clunking or driveline noise during acceleration or deceleration
• Excess play from worn CV joints or universal joints
• Damage to the original shaft tubes or yokes
• Need for a complete rear drive shaft replacement on a Nissan Rogue

Installation Notes

Verify rear-position fitment before ordering and compare the original shaft length, flange style, and mounting points to the vehicle. This assembly is pre-balanced and ready to install, but proper driveline alignment and torque procedures should be followed during service. Confirm that the vehicle matches the listed 2017-2019 Nissan Rogue rear application and that the existing driveline configuration matches the bolt-on end design.

Quality Assurance

Dorman supplies this drive shaft as a standard replacement assembly built with new components throughout the shaft, including yokes, tubes, CV joints, and universal joints. The design is intended to provide a complete replacement solution for rear driveline service on the Nissan Rogue.