Dorman 986-760 Drive Shaft - Rear

Rear Drive Shaft for Ford F-150

Dorman 986-760 is a complete rear drive shaft assembly for 2018-2020 Ford F-150 applications. It is pre-balanced and built with new yokes, tubes, constant velocity joints, and universal joints to simplify replacement on the rear driveline.

Key Features

• Fits 2018-2020 Ford F-150, rear
• Complete drive shaft assembly for direct replacement
• Pre-balanced for installation readiness
• 100% new yokes, tubes, CV joints, and universal joints
• Steel shaft construction
• Bolt-on ends at both sides
• Pre-greased with grease fitting included
• Phased design with 0 phase degrees
• Standard replacement grade
• Compressed length: 88.5 in; drive shaft length: 89.8 in

Detailed Description

This Dorman drive shaft assembly is built for rear-position service on the Ford F-150 and is engineered as a direct replacement for the original driveline component. The assembly uses steel construction, bolt-on end connections, and a pre-greased design to support a straightforward swap during driveline repair. Dorman 986-760 is also listed with interchange references JL3Z4R602AS and JL3Z4R602Y for the same application.

For shoppers searching for a rear drive shaft for 2018 Ford F-150, 2019 Ford F-150, or 2020 Ford F-150 rear driveline replacement, this assembly provides the key dimensions and hardware configuration needed for fitment-based selection. The shaft is adjustable overall and includes a multi-piece shaft design.

Common Problems This Part Can Address

• Vibration from a worn or out-of-balance rear drive shaft
• Clunking or driveline noise from worn joints
• Excess play caused by damaged yokes or tubes
• Service issues related to a failing rear shaft assembly
• Replacement needs after driveline wear or damage

Installation Notes and Tips

Confirm rear-position fitment before ordering and verify flange-to-flange length, compressed length, and end type against the original shaft. This assembly uses bolt-on ends and is pre-greased, so it is ready for installation once the vehicle is properly supported and the driveline is aligned to the original orientation.

Because the shaft is phased and pre-balanced, maintaining correct indexing during installation is important. Always inspect related driveline components, mounting points, and mating surfaces before final assembly on the Ford F-150.

Quality Assurance

Dorman 986-760 is a standard replacement drive shaft assembly built with new core components for service replacement. Its pre-balanced construction and complete assembly format are intended to reduce the need to rebuild the original shaft during repair.