Dorman 986-762 Drive Shaft - Rear

Dorman 986-762 Drive Shaft for Ram 2500

Dorman 986-762 is a complete rear drive shaft assembly for select 1997-2002 Dodge Ram 2500 trucks with Sales Code DHG and the 241HD transfer case. It arrives pre-balanced and built with new yokes, tubes, CV joints, and universal joints for a direct replacement approach.

Key Features

• Complete drive shaft assembly for the rear position
• Pre-balanced for installation readiness
• 100% new yokes, tubes, constant velocity joints, and universal joints
• Steel shaft construction with a 3.5 in. shaft diameter
• Pre-greased and phased at 0 degrees
• Slip yoke end 1 and universal joint end 2
• Compressed length: 83.5 in.; drive shaft length: 85 in.
• Standard replacement grade for select Dodge Ram 2500 applications

Detailed Description

This Dorman drive shaft assembly is built for 1997-2002 Dodge Ram 2500 rear driveline service where the original shaft has worn joints, vibration, or balance issues. Part number 986-762 uses a steel shaft with a 0.83 in. wall thickness, a 3 in. max slip, and an overall length adjustable design to match the listed application. It is pre-greased, includes universal joints, and does not include CV joints, axle nut, or grease fitting. This part cross-references Chrysler 52105537 for the same application.

Fits 1997-2002 Dodge Ram 2500, rear, with Sales Code DHG (Shift-On-The-Fly, 241HD Transfer Case). For Ram 2500 driveline repair, Dorman 986-762 provides a complete replacement assembly that addresses the full shaft rather than isolated wear points.

What It Helps Fix

• Driveline vibration from a worn or out-of-balance shaft
• Clunking or looseness from failed universal joints
• Noise caused by worn slip yoke movement
• Service issues from damaged tubes or yokes
• Rear driveline replacement needs on Dodge Ram 2500 trucks

Installation Notes and Tips

Verify the vehicle’s Sales Code DHG and 241HD transfer case before ordering. Confirm compressed length, flange-to-flange measurements, and rear position fitment against the original shaft. Because this assembly is pre-balanced and pre-greased, it is ready for installation once the application is confirmed. Check driveline angles and related mounts during replacement to help prevent repeat vibration concerns.

Quality Assurance

Dorman supplies this as a standard replacement driveline assembly with new major wear components already installed. The pre-balanced construction and new yokes, tubes, and joints support consistent fitment for the listed Dodge Ram 2500 applications. Part number 986-762 is built for direct replacement service in the specified rear driveline configuration.