Dorman 986-980 Drive Shaft - Rear

Dorman 986-980 Rear Drive Shaft

Dorman 986-980 is a complete rear drive shaft assembly for select Ford F-150 applications. It arrives pre-balanced and assembled with new yokes, tubes, universal joints, and CV joints, helping simplify replacement on the 2018-2020 Ford F-150, rear with 9.75 in. axle.

Key Features

• Complete drive shaft assembly for driveline replacement
• Pre-balanced for installation readiness
• 100% new yokes, tubes, constant velocity joints, and universal joints
• Steel shaft construction with 3.5 in. shaft diameter
• Pre-greased with grease fitting included
• Bolt-on end type at both ends
• Phased at 90 degrees
• Standard replacement grade
• Compressed length: 91.75 in.
• Drive shaft length: 92.75 in.

Detailed Description

This Dorman drive shaft is built for rear driveline service on the Ford F-150 and is listed for 2018, 2019, and 2020 models with the 9.75 in. axle. The assembly uses steel shaft material, includes universal joints, and is supplied pre-greased to support a straightforward replacement process. Part number 986-980 also cross-references JL3Z4R602J for the same application.

For buyers searching for a rear drive shaft for 2018-2020 Ford F-150 9.75 in. axle applications, this assembly provides the key dimensions and hardware configuration needed for a direct driveline service replacement. The shaft is not a multi-piece design, does not use a slip yoke, and is specified with overall length adjustable.

What It Helps Address

• Vibration from a worn or out-of-balance drive shaft
• Clunking or driveline noise from worn universal joints
• Service issues caused by damaged yokes or tubes
• Replacement needs after driveline wear or corrosion
• Rear driveline repair on a Ford F-150 with 9.75 in. axle

Installation Notes and Tips

Verify the vehicle is a 2018-2020 Ford F-150, rear, with the 9.75 in. axle before ordering. Confirm compressed length, flange-to-flange length, and bolt-on end type against the original shaft. Because the assembly is pre-balanced and phased, install it in the correct orientation and inspect mating surfaces, flange condition, and axle-side hardware during service.

Quality Assurance

Dorman supplies this as a standard replacement driveline assembly with new major wear components already installed. The pre-balanced construction and new yokes, tubes, CV joints, and universal joints support consistent fitment and service-ready replacement for the specified Ford F-150 applications.