DuraGo 295-12178 Wheel Bearing and Hub Assembly - Rear

DuraGo Rear Wheel Bearing Hub Assembly for Accord

The DuraGo 295-12178 wheel bearing and hub assembly is built for rear service on 1998-2002 Honda Accord models. It combines the hub and bearing into one replacement unit to restore smooth wheel rotation, reduce friction, and support consistent ABS operation.

• Fits 1998-2002 Honda Accord, rear
• Wheel bearing and hub assembly for non-driven rear applications
• 4-bolt wheel stud pattern with M12 x 1.5 wheel studs
• 114.3 mm / 4.5 in bolt circle
• ABS tone ring design with 50 sensor ring teeth
• Hub pilot diameter: 66 mm / 2.6 in
• Wheel pilot diameter: 64 mm / 2.52 in
• Brake pilot diameter: 64 mm / 2.52 in
• Flange diameter: 152 mm / 5.98 in
• Flange offset: 56 mm / 2.2 in

Detailed Product Information

DuraGo Part Number 295-12178 is a rear non-driven wheel bearing and hub assembly engineered for Honda Accord rear applications from 1998 through 2002. It is specified with ABS and a tone ring, making it a direct-fit option for vehicles that use wheel speed sensing at the hub. The assembly uses a 4-lug, 114.3 mm bolt pattern and M12 x 1.5 wheel studs, with hub and pilot dimensions that support proper wheel and brake component alignment. This part cross-references QuickSteer 512178 for the same application.

DuraGo manufactures hub assemblies using quality components and tests each unit before release. The brand states its hub assemblies are produced to ISO/TS 16949:2002 quality standards, which supports consistent fit and function for routine wheel-end service. If you are replacing a worn rear hub on a Honda Accord, Part Number 295-12178 is a focused OE-style service part for restoring wheel bearing performance and ABS signal integrity.

Common Reasons to Replace

• Rear wheel noise, growling, or rough rotation
• Excessive play or looseness at the wheel hub
• ABS warning light caused by hub-mounted tone ring issues
• Uneven wheel-end wear from a deteriorated bearing
• Vibration or instability from a worn rear hub assembly

Installation Notes

Verify rear fitment by matching the vehicle year, model, and ABS configuration before installation. Inspect the mating surfaces, axle area, and brake components for wear or corrosion during replacement. Confirm wheel stud pattern, pilot diameters, and flange dimensions against the original part to ensure proper seating on the Honda Accord rear hub location. Part Number 295-12178 is intended for rear use on the listed applications only.

Quality Assurance

DuraGo hub assemblies are 100% tested and manufactured to industry-leading quality standards. The brand also identifies ISO/TS 16949:2002 manufacturing compliance for this product line, supporting controlled production and repeatable fitment for wheel bearing and hub replacement service.