DuraGo 295-12212 Wheel Bearing and Hub Assembly - Rear

DuraGo Rear Wheel Bearing Hub Assembly

The DuraGo 295-12212 wheel bearing and hub assembly is built for the rear of select Toyota RAV4 models from 1996-2005. It is a non-driven hub assembly with ABS sensor type integration, made to replace worn hub components that can increase friction and affect drivability.

For Toyota RAV4 rear hub replacement needs, this DuraGo 295-12212 assembly is engineered to meet industry quality standards and is 100% tested before release.

Key Features

• Rear wheel bearing and hub assembly for 1996-2005 Toyota RAV4
• Non-driven type hub assembly
• ABS sensor type: sensor
• Wheel stud size: M12 x 1.5
• Wheel studs included
• 5 wheel studs and 4 flange bolt holes
• Hub pilot diameter: 84 mm
• Wheel pilot diameter: 60 mm
• Brake pilot diameter: 62 mm
• Flange diameter: 152 mm with trapezoid flange shape

Detailed Description

DuraGo 295-12212 is a rear wheel bearing and hub assembly for the Toyota RAV4, covering 1996-2005 model years. It is built with quality components and tested to meet DuraGo’s manufacturing standards, helping restore proper wheel support and reduce friction from a worn hub assembly. This part cross-references MOOG 512212 and Timken HA594504 for the same application.

The assembly includes ABS sensor type provisions and is configured as a non-driven hub, making it a direct replacement choice for rear hub service on the Toyota RAV4. If you are searching for a rear wheel bearing hub assembly for 1996-2005 Toyota RAV4, part number 295-12212 is the relevant reference.

What It Helps Address

• Wheel bearing noise from a worn rear hub assembly
• Excessive friction at the wheel hub
• ABS-related wheel speed sensor interface concerns at the hub
• Loose or unstable rear wheel support
• Restoration of proper rear hub operation on Toyota RAV4 models

Installation Notes and Tips

Verify rear fitment before installation on 1996-2005 Toyota RAV4 applications. Confirm the wheel stud size, hub pilot diameter, brake pilot diameter, and ABS sensor configuration against the original part. Inspect the mounting surface, axle area, and surrounding brake components for wear or damage before installing the new hub assembly.

Quality Assurance

DuraGo has over 45 years of aftermarket manufacturing experience. This hub assembly is assembled with quality components, 100% tested, and manufactured to industry-leading standards that meet ISO/TS 16949:2002 requirements.