DuraGo 295-12282 Wheel Bearing and Hub Assembly - Rear Left

DuraGo 295-12282 Rear Left Hub Assembly

DuraGo 295-12282 is a wheel bearing and hub assembly for the rear left position on select Lexus and Toyota vehicles. It is built with premium components and tested for fit and performance, making it a direct replacement for worn hub units that can increase friction and affect drivability.

• Fits 2007-2009 Lexus RX350, rear left
• Fits 2006-2008 Lexus RX400h, rear left
• Fits 2004-2007 Toyota Highlander, rear left
• Fits 2004-2006 Lexus RX330, rear left
• Non-driven hub assembly with ABS sensor type integration
• Wheel stud size: M12 x 1.5
• Wheel studs included: Yes
• Flange bolt hole quantity: 4
• Connector quantity: 1

Key Features

• Part number 295-12282 for rear left hub replacement
• Designed for vehicles with anti-lock braking system sensor input
• Modified flange shape with 5-lug wheel stud configuration
• Hub pilot diameter: 83.9 mm
• Wheel pilot diameter: 60 mm
• Brake pilot diameter: 62 mm
• Flange diameter: 151.9 mm
• Flange offset: 72 mm

Detailed Description

DuraGo 295-12282 is a rear left wheel bearing and hub assembly engineered for select Lexus RX330, Lexus RX350, Lexus RX400h, and Toyota Highlander applications. This non-driven hub assembly is built to restore proper wheel support and rotation while maintaining ABS sensor compatibility through a sensor-type interface. DuraGo assembles each hub unit with quality components and tests every unit to meet its published standards. The design follows ISO/TS 16949:2002 quality requirements and is intended for drivers replacing a worn hub that can create noise, looseness, or added rolling resistance. This part cross-references SKF BR930376 for the same application.

Common Problems This Part Can Address

• Wheel bearing noise from a worn rear hub assembly
• Excessive wheel play or looseness at the rear left corner
• ABS warning light concerns related to hub sensor function
• Uneven wheel rotation caused by hub wear
• Reduced fuel economy from increased friction in the hub assembly

Installation Notes and Tips

Confirm rear left fitment by year, make, and model before installation. Inspect the mating surfaces, axle area, and ABS connector condition during replacement. Verify wheel stud size, flange dimensions, and sensor connection alignment before final assembly. Because this is a non-driven hub assembly, it is used at the rear wheel position rather than a driven axle location.

Quality Assurance

DuraGo manufactures this hub assembly to industry-leading quality standards and tests each unit before release. The part is produced to meet ISO/TS 16949:2002 quality system requirements, supporting consistent fit and performance for the listed Lexus and Toyota applications.