DuraGo BD35085 Brake Drum - Rear

DuraGo BD35085 Rear Brake Drum

The DuraGo BD35085 is a cast iron rear brake drum built for specific Mitsubishi Lancer applications. It is engineered to match fit, form, and function requirements for direct replacement service on 2002-2007 Mitsubishi Lancer rear brake systems.

• Cast iron construction for durable brake service
• Full cast design
• Nominal drum diameter: 202.95 mm / 7.99 in
• Maximum brake diameter (discard): 205 mm / 8.07 in
• Outside diameter: 243 mm / 9.57 in
• Brake surface width: 42 mm / 1.65 in
• Center hole diameter: 90.1 mm / 3.55 in
• Bolt circle diameter: 114.3 mm / 4.5 in
• 4 bolt holes with 12.8 mm / 0.5 in diameter
• Overall height: 60 mm / 2.36 in

Fitment and Application

Compatible With 2007 Mitsubishi Lancer, rear. Compatible With 2002-2006 Mitsubishi Lancer, rear, 114 mm bolt circle. This part cross-references Four Seasons 35085 for the same application.

Use the BD35085 when replacing a worn rear brake drum on a Mitsubishi Lancer with the listed rear brake configuration. The drum dimensions, bolt pattern, and center bore are specified to support proper drum-to-hub alignment and brake shoe contact on the rear axle.

What This Brake Drum Helps Address

• Rear brake pulsation caused by drum wear or out-of-round condition
• Reduced braking consistency from a worn braking surface
• Noise from damaged or heat-affected drum surfaces
• Brake shoe contact issues related to drum diameter wear
• Fitment problems when replacing a drum with the wrong bolt circle or center bore

Installation Notes and Tips

Verify the rear brake drum dimensions against the existing part before installation, especially the bolt circle diameter, center hole diameter, and nominal drum diameter. Inspect brake shoes, wheel cylinders, and related rear brake components during service so the new drum can seat against a clean, even braking surface. Confirm the vehicle application matches the listed Mitsubishi Lancer year, model, and rear position before ordering.

Quality Assurance

DuraGo has over 45 years of aftermarket manufacturing experience and produces brake drums through ISO-certified factories. The BD35085 is built to meet fit, form, and function requirements for the specified Mitsubishi Lancer rear brake applications.