DuraGo BD80099-01 Brake Drum - Rear

DuraGo Brake Drum for Rear Fitment

The DuraGo BD80099-01 brake drum is built for rear applications on select Ford Taurus and Mercury Sable models. It combines cast iron construction with a corrosion-resistant coating to help maintain braking performance and exterior appearance in everyday driving.

Key Features

• Cast iron construction for stable braking performance
• Rust-resistant coating on the exterior, hat, and edge
• Titanium gray finish suited to open wheel designs
• Outer cooling fins for improved heat management
• ISO-certified manufacturing for fit, form, and function
• Nominal drum diameter: 8.86 in. (225 mm)
• Outside diameter: 10.51 in. (267 mm)
• Brake surface width: 2.17 in. (55.1 mm)
• 5-bolt pattern with 4.25 in. bolt circle diameter

Detailed Description

DuraGo BD80099-01 is a rear brake drum engineered from full cast construction and finished with a corrosion-resistant coating for added protection against exterior rust. The titanium gray surface helps the drum present cleanly on vehicles with open wheel designs, while the cooling-fin design supports heat dissipation during repeated braking. Manufactured in an ISO certified factory, this brake drum is built to meet fit, form, and function requirements for the listed applications. This part cross-references OE-style numbers 1F1Z1126BA and 4U2Z1V126AA for the same application. The DuraGo BD80099-01 is a direct-fit choice for rear brake service on 2001-2007 Ford Taurus and 2001-2005 Mercury Sable models.

Vehicle Fitment

• Fits 2001-2007 Ford Taurus, rear. Coated hat and edge for rust resistance.
• Fits 2001-2005 Mercury Sable, rear. Coated hat and edge for rust resistance.

Common Uses

• Replacing a worn rear brake drum with scoring or heat damage
• Addressing rust buildup on the drum exterior or braking surface area
• Restoring rear brake performance on Ford Taurus and Mercury Sable applications
• Correcting brake pulsation or noise caused by drum wear
• Supporting consistent rear braking during routine brake service

Installation Notes and Tips

Verify drum diameter, bolt pattern, and rear axle application before installation. Inspect brake shoes, hardware, and wheel cylinders during service, and measure the existing drum against the discard diameter specification of 8.92 in. (226.5 mm) to confirm replacement timing. Clean the braking surface and hub contact area before mounting the new drum.

Quality Assurance

DuraGo manufactures this brake drum in an ISO certified facility and applies its experience in brake component design to meet fitment and functional requirements for the listed vehicles.