DuraGo BD920132 Brake Drum - Rear

DuraGo BD920132 Rear Brake Drum

The DuraGo BD920132 is a cast iron rear brake drum built for 2009-2011 Ford Focus applications. It is engineered to match the required fit, form, and function for a direct brake service replacement, with dimensions that support proper drum-to-shoe contact and consistent braking performance.

For shoppers searching for a rear brake drum for 2009-2011 Ford Focus, BD920132 provides the key dimensions needed for a correct application match. This DuraGo brake drum is made by ISO-certified factories and reflects the brand’s long-running focus on aftermarket brake components.

Key Features

• Cast iron construction for durable brake service
• Full cast design
• Nominal drum diameter: 203 mm / 7.99 in
• Maximum brake diameter discard: 204.3 mm / 8.04 in
• Outside diameter: 238.9 mm / 9.41 in
• Brake surface width: 45 mm / 1.77 in
• Center hole diameter: 63.3 mm / 2.49 in
• Bolt circle diameter: 108 mm / 4.25 in
• 4-bolt pattern with M12 x 1.5 bolt size
• Overall height: 81.5 mm / 3.21 in

Detailed Description

DuraGo BD920132 is a rear brake drum for 2009-2011 Ford Focus models. The cast iron, full cast construction supports stable braking surfaces, while the listed drum diameter, bolt pattern, center hole size, and overall height help confirm proper fitment during brake repair. This part cross-references PRT 920132 for the same application.

DuraGo has a long history in the aftermarket and manufactures brake drums through ISO-certified factories with attention to fit, form, and function. If you are replacing a worn rear drum on a Ford Focus, BD920132 is a direct-fit option to compare against OE dimensions and service requirements.

What It Helps Address

• Rear brake pulsation caused by drum wear or out-of-round condition
• Reduced braking consistency from a worn braking surface
• Noise from damaged or heat-affected drum surfaces
• Fitment issues when replacing a rear drum on a 2009-2011 Ford Focus
• Brake service needs tied to corrosion-free dimensional replacement, where applicable

Installation Notes and Tips

Compatible With 2009-2011 Ford Focus, rear. Verify drum diameter, bolt circle, center hole, and overall height before installation. The fitment notes specify that a new wheel hub retaining nut should be installed after loosening or when the nut is not tightened to specification, and torque should be set to 173 ft-lbs (235 Nm) while rotating. The notes also state that the brake drum should be rotated counterclockwise during tightening to avoid wheel bearing damage, and that a new dust cap and dust shield must be installed to prevent bearing damage.

For best results, inspect the rear brake shoes, wheel bearing condition, and related hardware during service so the new drum can seat correctly and operate within specification.

Quality Assurance

DuraGo brake drums are manufactured by ISO-certified factories and built to meet fit, form, and function requirements for the listed application. BD920132 is part of DuraGo’s brake drum and rotor program, which is positioned for professional repair use and catalog accuracy.