DuraGo BD920166 Brake Drum - Rear

DuraGo Rear Brake Drum for Nissan Versa

The DuraGo BD920166 is a cast iron rear brake drum built for specific Nissan compact applications. It is engineered to match fit, form, and function requirements for direct replacement service on the rear brake system.

Key Features

• Cast iron construction for dependable braking performance
• Full cast design
• Nominal drum diameter: 203.5 mm (8.01 in.)
• Maximum brake diameter discard: 204.2 mm (8.04 in.)
• Outside diameter: 237 mm (9.33 in.)
• Brake surface width: 44.8 mm (1.76 in.)
• 4-bolt hole pattern with 100 mm (3.94 in.) bolt circle diameter
• Center hole diameter: 60 mm (2.36 in.)
• Overall height: 75 mm (2.95 in.)
• No ABS tone ring included
• No outer cooling fins

Detailed Description

DuraGo BD920166 is a rear brake drum for 2012-2019 Nissan Versa and 2014-2019 Nissan Versa Note rear brake applications. The drum is manufactured in ISO certified factories and reflects DuraGo’s focus on catalog accuracy and OE-style fitment for aftermarket brake service. This part cross-references PRT 920166 for the same application.

For Nissan Versa and Nissan Versa Note rear brake repairs, this drum provides the core dimensions needed for proper drum brake service, including the specified bolt pattern, center bore, and braking surface width. The cast iron, full cast construction supports consistent brake contact and service replacement on the rear axle.

Common Problems This Part Helps Address

• Rear brake pulsation caused by worn or out-of-spec drum surfaces
• Brake noise from scored or heat-affected drum material
• Reduced braking consistency from excessive drum wear
• Service failures tied to incorrect drum diameter or fitment
• Rear brake maintenance on 2012-2019 Nissan Versa and 2014-2019 Nissan Versa Note models

Installation Notes and Tips

Verify rear axle fitment, bolt pattern, center hole diameter, and drum diameter before installation. Measure the existing drum and compare it to the discard specification to confirm replacement timing. Clean the hub mounting surface and inspect rear brake shoes, hardware, and wheel cylinders during service to ensure even contact with the new drum.

Quality Assurance

DuraGo has over 45 years of aftermarket manufacturing experience, and this brake drum is produced in ISO certified factories to meet fit, form, and function requirements. The BD920166 is built for direct replacement use on the specified Nissan Versa and Nissan Versa Note rear brake applications.