DuraGo BR31247 Disc Brake Rotor - Front

DuraGo BR31247 Front Vented Brake Rotor

The DuraGo BR31247 is a front disc brake rotor built from cast iron with a full cast construction for Subaru and Saab applications that call for a 277 mm front rotor. It is a conventional, non-directional vented rotor with a 5-lug bolt pattern and OE-style dimensions for direct replacement service.

Key Features

• Cast iron construction with full cast design
• Vented rotor for front brake applications
• Outside diameter: 10.89 in. / 276.5 mm
• Nominal thickness: 0.94 in. / 24 mm
• Discard thickness: 0.87 in. / 22 mm
• 5 mounting bolt holes with 100 mm bolt circle diameter
• Center hole diameter: 2.28 in. / 58 mm
• Non-directional brake surface for straightforward service
• Conventional rotor design, not cross-drilled or slotted

Product Details

DuraGo has over 45 years of aftermarket manufacturing experience, and the BR31247 reflects that focus on fit, form, and function. Manufactured in ISO certified factories, this front brake rotor is built for applications including Subaru BRZ, Subaru Impreza, Subaru Forester, Subaru Legacy, Subaru Outback, and Saab 9-2X models that use the specified front rotor dimensions. This part cross-references Raybestos Brakes 96658 for the same application.

Common Brake Issues This Rotor Addresses

• Front brake pulsation caused by worn rotor thickness
• Brake noise related to uneven rotor wear
• Reduced braking consistency from heat-worn rotor surfaces
• Service replacement for rotors at or near discard thickness
• OE-style rotor replacement for Subaru BRZ, Subaru Impreza, and related front brake applications

Installation Notes and Tips

Verify rotor diameter, bolt pattern, center hole diameter, and thickness before installation. This rotor is for front position use only and is not cross drilled or slotted. For best results, inspect pads, calipers, and hub surfaces during brake service, and confirm fitment against the vehicle’s brake package, especially on Subaru Legacy and Subaru Outback applications with specific wheel or rotor requirements.

Quality Assurance

DuraGo manufactures brake components in ISO certified factories and focuses on catalog accuracy and OE-style fitment. The BR31247 is produced to meet requirements for fit, form, and function.