DuraGo BR31332-01 Disc Brake Rotor - Front

DuraGo BR31332-01 Front Brake Rotor

The DuraGo Titanium Series BR31332-01 is a front disc brake rotor built from cast iron with a vented, full-cast construction. It features a corrosion-resistant coating on the hat and edge to help protect exposed surfaces, along with a titanium gray finish that suits open-wheel styling.

Compatible With 2004-2006 Scion xA and 2004-2006 Scion xB front brake applications, this rotor is manufactured in an ISO-certified factory to support fit, form, and function requirements. The BR31332-01 is a direct-fit option for drivers and technicians looking for a coated front rotor for these Scion models.

Key Features

• Part number BR31332-01
• Front disc brake rotor for Scion xA and Scion xB applications
• Cast iron, full-cast construction
• Vented rotor design
• Rust-resistant coating on the hat and edge
• Titanium gray finish for a clean appearance behind open wheels
• Non-directional brake surface
• 4-bolt mounting pattern
• Outside diameter: 255 mm (10.04 in.)
• Nominal thickness: 22 mm (0.87 in.)
• Discard thickness: 20 mm (0.79 in.)

Detailed Description

DuraGo BR31332-01 is engineered as a conventional front rotor with a 255 mm outside diameter, 55.2 mm center hole diameter, and 100 mm bolt circle diameter. The vented design helps support heat management during braking, while the coated hat and edge add corrosion resistance where rotors are most exposed. This makes it a practical replacement choice for 2004-2006 Scion xA and 2004-2006 Scion xB front brake service.

This part cross-references 4351252080 for the same application.

What This Rotor Helps Address

• Front brake pulsation caused by worn rotor surfaces
• Brake noise related to uneven or damaged rotor faces
• Visible rust on the hat and outer edge of the rotor
• Reduced braking consistency from rotor wear
• Service replacement needs for Scion xA and Scion xB front brakes

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and hub fitment before installation. Clean the hub mounting surface thoroughly to help prevent runout concerns, and inspect pads, calipers, and hardware condition during brake service. Follow the vehicle manufacturer’s torque specifications and bedding procedure after installation.

Quality Assurance

DuraGo manufactures DTS rotors in an ISO-certified factory and builds them to meet fit, form, and function requirements. The Titanium Series focuses on corrosion protection and consistent replacement performance for everyday brake service.