DuraGo BR3489 Disc Brake Rotor - Rear

DuraGo BR3489 Rear Disc Brake Rotor

The DuraGo BR3489 is a rear disc brake rotor built for specific Volvo applications, including Volvo 240, 740, 760, 780, 940, 960, 745, DL, and GLE models. It uses a full cast, cast iron construction with a solid, non-directional brake surface for consistent braking performance.

Key Features

• Cast iron, full cast rotor construction
• Solid rotor design with non-directional brake surface
• Outside diameter: 11.06 in. (281 mm)
• Nominal thickness: 0.38 in. (9.6 mm)
• Discard thickness: 0.33 in. (8.4 mm)
• Overall height: 2.88 in. (73.2 mm)
• 5-bolt mounting pattern with 4.25 in. (108 mm) bolt circle
• Center hole diameter: 2.68 in. (68 mm)
• Drum-in-hat rotor design
• No cross-drilling, no slots, no ABS tone ring

Product Details

DuraGo BR3489 is a rear brake rotor engineered for fitment on select Volvo rear brake applications, including 1990-1993 Volvo 240 rear, 1991-1993 Volvo 740 rear, 1988-1990 Volvo 740 rear with ATE calipers, 1983-1987 Volvo 760 rear, 1988-1990 Volvo 760 rear with ATE calipers, 1987 Volvo 780 rear, 1991-1992 Volvo 740 rear, 1994-1995 Volvo 940 rear without IRS and with ATE, and 1995-1997 Volvo 960 rear without Multi Link suspension. DuraGo manufactures brake components through ISO-certified factories with attention to fit, form, and function, and this part cross-references Anchor (e.g., 3489, 9983) for the same application.

Common Uses

• Replacing a worn rear brake rotor on a Volvo 240, 740, 760, 780, 940, or 960
• Correcting brake pulsation caused by rotor wear or thickness variation
• Restoring rear braking surface condition after scoring or heat checking
• Addressing brake noise related to rotor surface damage
• Maintaining proper rear brake service on drum-in-hat rotor setups

Installation Notes

Verify rear axle and suspension configuration before ordering, especially on Volvo 940 and 960 applications with IRS or Multi Link suspension notes. Confirm rotor dimensions, bolt pattern, and center bore against the existing part before installation. For best results, inspect pads, calipers, and hub surfaces during brake service and follow the vehicle manufacturer’s service procedure.

Quality Assurance

DuraGo brake rotors are produced in ISO-certified factories and built to meet fit, form, and function requirements for aftermarket brake service. The BR3489 reflects DuraGo’s cataloging focus for professional brake applications and is manufactured to support consistent replacement quality.