DuraGo BR5448 Disc Brake Rotor and Hub Assembly - Front

DuraGo BR5448 Front Disc Brake Rotor and Hub Assembly

The DuraGo BR5448 is a front disc brake rotor and hub assembly built for select Ford Ranger, Explorer, and Bronco II applications. It combines the rotor and hub into one service part, with a vented design, 5-stud pattern, and included bearing cups for a direct replacement on listed vehicles.

Key Features

• Front disc brake rotor and hub assembly for select Ford applications
• Vented rotor design for front brake service
• Rotor outside diameter: 10.87 in. (276 mm)
• Nominal thickness: 0.87 in. (22.1 mm)
• Discard thickness: 0.81 in. (20.6 mm)
• 5-stud wheel pattern with 1/2-20 stud thread size
• Mounting bolt hole circle diameter: 4.5 in. (114.3 mm)
• Overall height: 2.17 in. (55.1 mm)
• Inner bearing cup included
• Outer bearing cup included
• Wheel studs included
• Non-directional brake surface

Detailed Description

DuraGo BR5448 is manufactured for fit, form, and function in professional brake service. DuraGo has over 45 years of aftermarket manufacturing experience, and this rotor and hub assembly is produced in ISO-certified factories to support consistent dimensional accuracy and dependable installation on the listed Ford Ranger, Ford Explorer, and Ford Bronco II front axle applications. The vented rotor construction and non-directional braking surface support even pad contact during routine brake replacement.

This part cross-references FEL-PRO 60693 and CSF 6005 for the same application. The BR5448 part number is also referenced in aftermarket catalogs under 5448 and related interchange numbers for select front brake service.

Common Issues This Part Helps Address

• Front brake pulsation caused by worn rotor surfaces
• Excessive rotor wear below discard thickness
• Noise or uneven braking from damaged hub/rotor components
• Service needs on front wheel bearing cup and stud-equipped assemblies
• Brake maintenance on vehicles with the specified 5-lug front setup

Installation Notes and Tips

Verify rotor diameter, thickness, stud pattern, and bearing cup requirements before installation. Confirm the vehicle’s front axle configuration and application notes, including the Ranger axle code and Explorer/Bronco II height notes where listed. Clean the hub mounting surface thoroughly and inspect pads, bearings, and related hardware for wear before completing brake service. Always follow the vehicle manufacturer’s service procedure and torque specifications.

Quality Assurance

DuraGo manufactures this rotor and hub assembly in ISO-certified factories and builds its brake program around catalog accuracy and application coverage. The BR5448 is engineered to meet fit, form, and function requirements for the listed vehicles.