DuraGo BR900532 Disc Brake Rotor - Rear

DuraGo BR900532 Rear Disc Brake Rotor

The DuraGo BR900532 is a rear drum-in-hat disc brake rotor built from cast iron for specific Honda and Acura applications. It is a solid, non-directional rotor with a full cast construction and the dimensions needed for proper rear brake service on select Odyssey, Pilot, MDX, and ZDX models.

• Cast iron construction for dependable braking performance
• Full cast, solid rotor design
• Non-directional brake surface
• Drum-in-hat rotor configuration
• 5 mounting bolt holes with a 120 mm bolt circle
• Outside diameter: 13.13 in. / 333.5 mm
• Center hole diameter: 2.76 in. / 70.2 mm
• Nominal thickness: 0.43 in. / 11 mm
• Discard thickness: 0.35 in. / 9 mm
• No cross-drilling, no slots, and no ABS tone ring included

Fitment and Application Details

Fits 2011-2017 Honda Odyssey, rear. Fits 2009-2015 Honda Pilot, rear. Fits 2007-2013 Acura MDX, rear. Fits 2010-2013 Acura ZDX, rear. This part cross-references Raybestos Brakes 980567 for the same application.

For rear brake rotor replacement on a Honda Odyssey, Honda Pilot, Acura MDX, or Acura ZDX, BR900532 matches the listed dimensions and drum-in-hat configuration. The rotor’s 5-bolt pattern, 120 mm bolt circle, and 63.7 mm overall height support correct fitment on the specified rear brake assemblies. DuraGo manufactures this rotor through ISO-certified factories and builds its brake drum and rotor program around fit, form, and function requirements for aftermarket service.

Common Problems This Rotor Can Address

• Rear brake pulsation from rotor wear or thickness variation
• Brake noise caused by worn or uneven rotor surfaces
• Reduced braking consistency from a rotor below discard thickness
• Corrosion-related service issues on a worn rear rotor
• Fitment problems when replacing the rear drum-in-hat rotor on listed Honda and Acura models

Installation Notes and Quality Assurance

Verify rotor dimensions, bolt pattern, and rear drum-in-hat configuration before installation. Clean the hub mounting surface, inspect related brake components, and confirm the rotor meets the vehicle’s required thickness specifications. BR900532 is manufactured by DuraGo in ISO-certified factories and reflects the brand’s long-running aftermarket brake program focused on catalog accuracy and dimensional consistency.