DuraGo BR900714 Disc Brake Rotor - Rear

DuraGo BR900714 Rear Rotor for Maxima

The DuraGo BR900714 is a rear disc brake rotor built for 2009-2023 Nissan Maxima applications. It uses full cast iron construction and a vented, drum-in-hat design to match the braking layout used on these vehicles.

Key Features

• Fits 2009-2023 Nissan Maxima, rear
• Part number BR900714
• Cast iron, full cast construction
• Vented rotor design
• Non-directional brake surface
• 5-bolt mounting pattern with 114.3 mm bolt circle
• 12.13 in. outside diameter and 2.68 in. center hole diameter
• Nominal thickness: 0.63 in. (16 mm); discard thickness: 0.55 in. (14 mm)

Detailed Description

DuraGo BR900714 is a rear brake rotor for Nissan Maxima models from 2009 through 2023. The rotor is manufactured from cast iron in a full cast construction and uses a vented, drum-in-hat configuration with a non-directional braking surface. Key dimensions include a 12.13-inch outside diameter, 2.44-inch overall height, 5 mounting bolt holes, and a 114.3 mm bolt circle. DuraGo manufactures its brake drum and rotor program in ISO-certified factories, with attention to fit, form, and function for aftermarket brake service.

This part cross-references Raybestos Brakes 980710 for the same application.

What It Helps Address

• Brake pulsation caused by rotor wear or thickness variation
• Reduced rear braking performance from a worn rotor surface
• Noise from a rotor that is below discard thickness
• Service replacement needs on 2009-2023 Nissan Maxima rear brake systems
• Brake service when the original rear rotor is no longer within specification

Installation Notes and Tips

Verify rotor dimensions, hub fit, and rear axle application before installation. Inspect pads, caliper hardware, and wheel bearing condition during brake service, and measure rotor thickness to confirm the existing part is at or below discard limits. For best results, clean the hub mounting surface before installing the new rotor.

Quality Assurance

DuraGo brake rotors are produced in ISO-certified factories and built to meet fit, form, and function requirements for aftermarket brake service. BR900714 is engineered for direct replacement use on listed Nissan Maxima rear applications.