DuraGo BR900754-01 Disc Brake Rotor - Rear

DuraGo Titanium Series Rear Rotor

The DuraGo Titanium Series brake rotor is a rear disc brake rotor built for the 2009-2013 Toyota Matrix and 2009-2010 Pontiac Vibe. Part number BR900754-01 combines cast iron construction with a corrosion-resistant titanium gray coating for the hat and edge.

It is a solid, non-directional rotor with a full cast design and OE-style dimensions for fit, form, and function. The finish also helps the rotor look cleaner behind open wheel designs on the Toyota Matrix and Pontiac Vibe.

Key Features

• Cast iron, full cast construction
• Rust-resistant coating on the hat and edge
• Titanium gray finish for a cleaner appearance behind open wheels
• Solid, non-directional brake surface
• Drum-in-hat rotor design for rear applications
• ISO-certified manufacturing for dimensional consistency
• Part number BR900754-01

Detailed Description

DuraGo BR900754-01 is a rear disc brake rotor engineered for vehicles that use a drum-in-hat rear brake setup. It measures 11.06 inches in outside diameter, 2.17 inches in overall height, and 0.39 inches nominal thickness, with a 5-lug bolt pattern, 114.3 mm bolt circle, and 62 mm center hole diameter. The rotor is solid rather than vented and does not include an ABS tone ring.

For fitment-specific searches, this rotor fits 2009-2013 Toyota Matrix, rear, and fits 2009-2010 Pontiac Vibe, rear. The corrosion-resistant coating helps protect the hat and edge from rust, while the non-directional surface supports straightforward brake service and consistent contact.

This part cross-references OE-style applications for the same rear brake setup.

Common Issues It May Address

• Brake pulsation from a worn or uneven rear rotor
• Rust buildup on the rotor hat and edge
• Reduced braking performance from rotor wear below discard thickness
• Noise caused by surface irregularity or corrosion
• Replacement needs for a rear drum-in-hat rotor service

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and rear drum-in-hat configuration before installation. Inspect pads, caliper hardware, and hub surfaces for wear or corrosion, and clean the mounting face so the rotor seats properly. Confirm the rotor is installed on the rear axle position only for the listed Toyota Matrix and Pontiac Vibe applications.

Quality Assurance

DuraGo manufactures this rotor in an ISO-certified factory to meet fit, form, and function requirements. The Titanium Series is built from DuraGo’s two decades of brake component experience and includes a corrosion-resistant coating for added protection.