DuraGo BR900998-01 Disc Brake Rotor - Front

DuraGo BR900998-01 Front Brake Rotor

The DuraGo Titanium Series BR900998-01 is a front disc brake rotor built for 2011-2015 Mazda 2 applications. It combines a corrosion-resistant coating with a titanium gray finish that helps protect the hat and edge while giving the rotor a clean appearance behind open wheel designs.

Key Features

• Fits 2011-2015 Mazda 2, front
• Part number: BR900998-01
• Vented, conventional disc brake rotor
• Cast iron, full cast construction
• Rust-resistant coating on the hat and edge
• Non-directional brake surface for service flexibility
• 4-bolt mounting pattern with 100 mm bolt circle
• Outside diameter: 258 mm (10.16 in)
• Center hole diameter: 55 mm (2.17 in)
• Nominal thickness: 23 mm (0.91 in)
• Discard thickness: 21 mm (0.83 in)

Detailed Description

DuraGo BR900998-01 is engineered as a front replacement disc brake rotor for Mazda 2 models from 2011 through 2015. The vented design supports heat management during braking, while the cast iron full-cast construction provides the structural foundation expected in a service rotor. The corrosion-resistant coating helps defend the hat and edge from rust, and the titanium gray finish is suited to vehicles with open wheel styling. Manufactured in an ISO-certified factory, this rotor is built to meet fit, form, and function requirements for the listed Mazda 2 front brake application. This part cross-references Monroe Shocks & Struts (e.g., DF7133251, DF7133251A) for the same application.

Common Problems This Rotor Can Address

• Front brake pulsation caused by worn or uneven rotor surfaces
• Rust buildup on the rotor hat and outer edge
• Reduced braking consistency from rotor wear near discard thickness
• Noisy braking associated with damaged or heat-affected rotors
• Service replacement needs on 2011-2015 Mazda 2 front brake systems

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and center bore before installation on the Mazda 2 front axle. Inspect pads, caliper hardware, and hub condition at the same time so the new rotor seats evenly and performs as expected. Clean the rotor surface before service to remove any protective residue from packaging and follow the vehicle manufacturer’s brake service procedures.

Quality Assurance

DuraGo manufactures this rotor in an ISO-certified facility and designs it to meet fit, form, and function requirements for the specified application. The Titanium Series coating is used to provide lasting corrosion protection on the hat and edge, supporting long-term service on 2011-2015 Mazda 2 front brake repairs.