DuraGo BR901308 Disc Brake Rotor and Hub Assembly - Front

DuraGo BR901308 Front Disc Brake Rotor and Hub Assembly

The DuraGo BR901308 is a front disc brake rotor and hub assembly built for 1995-1999 Chevrolet P30 applications with a DRW and I-Beam front axle. It combines rotor, hub, bearing cups, wheel studs, and an ABS tone ring in one service part for a direct replacement on the front axle.

Key Features

• Fits 1995-1999 Chevrolet P30, front
• Vented rotor design for front brake service
• Rotor outside diameter: 12.51 in. (317.8 mm)
• Nominal thickness: 1.54 in. (39 mm); discard thickness: 1.46 in. (37.2 mm)
• 8-stud hub with 9/16-18 stud thread size
• ABS tone ring included
• Inner bearing cup included
• Outer bearing cup included
• Wheel studs included
• Non-directional brake surface

Detailed Description

Built for front axle brake service, the BR901308 is a DuraGo disc brake rotor and hub assembly for Chevrolet P30 trucks and chassis applications. The vented rotor design supports heat management during repeated stops, while the non-directional braking surface simplifies service preparation. With the hub, bearing cups, wheel studs, and ABS tone ring integrated into the assembly, this part supports a complete front-end brake refresh on the specified P30 fitment.

DuraGo has more than 45 years of aftermarket manufacturing experience and produces brake components through ISO-certified factories focused on fit, form, and function. This part cross-references Four Seasons 55064 and 56750 for the same application. The BR901308 part number is also referenced in interchange listings for service lookup and catalog matching.

Common Problems This Part Can Address

• Front brake pulsation from a worn or out-of-spec rotor
• Noise or vibration caused by hub and rotor wear
• ABS warning concerns related to a damaged tone ring
• Loose or worn wheel stud service on the front hub
• Brake service on a Chevrolet P30 front axle with DRW and I-Beam front axle notes

Installation Notes and Tips

Verify the vehicle is a 1995-1999 Chevrolet P30 with DRW and I-Beam front axle configuration before installation. Inspect bearings, seals, and related front-end components during service, and confirm rotor thickness and hub condition against the vehicle’s brake specifications. Clean all mating surfaces thoroughly and follow the manufacturer’s service procedures for torque and bearing adjustment.

Quality Assurance

DuraGo manufactures brake components in ISO-certified factories and builds this rotor and hub assembly to meet fit, form, and function requirements for the listed application. The BR901308 is engineered for direct replacement use on the confirmed Chevrolet P30 front fitment.