DuraGo BR901534 Disc Brake Rotor - Front

DuraGo BR901534 Front Brake Rotor

The DuraGo BR901534 is a front disc brake rotor built for select Audi applications with a 314 mm rotor diameter. It uses full cast iron construction and a vented design to support consistent braking performance on the front axle.

Key Features

• Cast iron construction for dependable braking strength
• Vented rotor design for front brake applications
• Non-directional brake surface for straightforward service preparation
• Conventional rotor design with no cross-drilling or slots
• 5-bolt mounting pattern with 112 mm bolt circle diameter
• Outside diameter: 314 mm; nominal thickness: 25 mm
• Center hole diameter: 68 mm; overall height: 52.3 mm

Detailed Description

DuraGo BR901534 is a conventional front brake rotor engineered for vehicles that use a 314 mm rotor diameter and a 5-lug hub pattern. Its full cast iron construction and vented profile provide the structural characteristics expected in a direct replacement rotor, while the non-directional surface supports standard brake service procedures. This rotor is listed for 2017-2020 Audi A4 front applications, 2018-2025 Audi A5 Sportback front applications, and 2021-2025 Audi A4 Quattro front applications. This part cross-references OE numbers 8W0615301G and 8W0615301T for the same application. The BR901534 is a practical choice when replacing a worn front rotor on Audi A4, Audi A4 Quattro, or Audi A5 Sportback models that match the specified brake setup.

What This Rotor Helps Address

• Brake pulsation caused by rotor wear or thickness loss
• Reduced braking consistency from an overheated or fatigued front rotor
• Noise or vibration associated with uneven rotor surfaces
• Service replacement for a rotor that has reached discard thickness
• Front brake maintenance on Audi A4, Audi A4 Quattro, and Audi A5 Sportback models

Installation Notes and Tips

Verify rotor diameter, center bore, bolt circle, and thickness before installation. This rotor is for front position use only and is specified for vehicles with a 314 mm rotor diameter. Inspect pads, calipers, and hub surfaces during service, and clean the mounting face before installing the new rotor to help ensure proper seating.

Quality Assurance

DuraGo has over 45 years of aftermarket manufacturing experience, and its brake drum and rotor program is produced in ISO-certified factories with attention to fit, form, and function. BR901534 reflects that manufacturing approach for Audi brake service applications.