DuraGo BR901608 Disc Brake Rotor - Rear

DuraGo Rear Disc Brake Rotor for Honda and Acura

The DuraGo BR901608 is a rear disc brake rotor built for select Honda and Acura applications, including the Honda CR-V, Honda HR-V, Acura TLX, and Acura ADX. It uses a full cast, cast iron construction with a solid rotor design and a non-directional brake surface for consistent braking contact.

Key Features

• Part number BR901608 rear disc brake rotor
• Cast iron, full cast construction
• Solid rotor design for rear brake applications
• Non-directional brake surface
• 5-bolt mounting pattern with 114.3 mm bolt circle
• Outside diameter: 310 mm (12.2 in.)
• Nominal thickness: 10 mm (0.39 in.)
• Discard thickness: 8.4 mm (0.33 in.)
• Center hole diameter: 64 mm (2.52 in.)
• Overall height: 38.8 mm (1.53 in.)

Detailed Description

DuraGo manufactures aftermarket brake components through ISO-certified factories with attention to fit, form, and function. The BR901608 rotor is engineered as a conventional, non-drilled, non-slotted rear rotor for vehicles that use a solid disc design. Its cast iron construction and precise dimensions support proper rotor fitment on the rear axle of 2017-2026 Honda CR-V, 2023-2026 Honda HR-V, 2015-2020 Acura TLX, and 2025-2026 Acura ADX applications. This part cross-references Honda 42510TLAA00 for the same application. The DuraGo BR901608 is a direct-fit replacement choice for drivers searching for a rear brake rotor for Honda CR-V rear, Honda HR-V rear, Acura TLX rear, or Acura ADX rear service.

Common Reasons to Replace

• Brake pulsation from rotor wear or thickness variation
• Reduced braking smoothness from an uneven rotor surface
• Rotor scoring or surface damage from pad wear
• Rotor thickness approaching discard specification
• Rear brake service on a Honda CR-V, Honda HR-V, Acura TLX, or Acura ADX

Installation Notes and Tips

Verify rear axle fitment by year, make, and model before installation. Inspect brake pads, caliper hardware, and hub condition during service, and clean the hub mounting surface so the rotor seats evenly. Measure rotor thickness after installation to confirm it remains above discard specification. For best results, follow the vehicle manufacturer’s brake service procedures and torque specifications.

Quality Assurance

DuraGo brake rotors are produced in ISO-certified factories and built to meet requirements for fit, form, and function. The BR901608 reflects DuraGo’s long-running aftermarket brake program and its focus on consistent cataloging and application coverage.