DuraGo BR901964-01 Disc Brake Rotor - Front

DuraGo BR901964-01 Front Brake Rotor

The DuraGo Titanium Series BR901964-01 is a front disc brake rotor built for Jeep Grand Cherokee and Jeep Grand Cherokee L applications that call for a 354 mm vented rotor. Its corrosion-resistant coating protects the hat and edge, while the titanium gray finish suits open-wheel designs.

Key Features

• Cast iron, full cast construction for consistent braking performance
• Vented, non-directional rotor surface for straightforward service fitment
• Rust-resistant coating on the hat and edge for added corrosion defense
• 13.94 in. outside diameter, 2.05 in. overall height
• 5-bolt mounting pattern with 127 mm bolt circle and 72 mm center hole
• Cross-drilled and slotted design not used for this rotor

Detailed Description

DuraGo BR901964-01 is engineered as a conventional front brake rotor for vehicles requiring a 354 mm diameter, vented disc. Manufactured in an ISO-certified factory, it is built to meet fit, form, and function requirements for the listed Jeep applications. The titanium gray coating adds corrosion protection and gives the rotor a clean appearance behind open wheels. This part cross-references Mopar 68463427AA for the same application.

Compatible With 2022-2025 Jeep Grand Cherokee, front and 2021-2025 Jeep Grand Cherokee L, front. Use BR901964-01 when replacing a front rotor on these Jeep models and matching the specified 354 mm rotor diameter.

What It Helps Address

• Brake pulsation from a worn or below-spec front rotor
• Corrosion on the rotor hat and outer edge
• Noise or uneven braking caused by rotor surface wear
• Fitment issues when the vehicle requires a 354 mm vented front rotor
• Service replacement needs for Jeep Grand Cherokee and Grand Cherokee L front brakes

Installation Notes and Tips

Verify rotor diameter, center hole, bolt pattern, and thickness before installation. This rotor is non-directional and does not include an ABS tone ring. Confirm the vehicle is equipped for the listed front application and inspect pads, caliper hardware, and hub condition during brake service.

Quality Assurance

DuraGo manufactures the BR901964-01 in an ISO-certified facility and applies its Titanium Series corrosion-resistant coating for added protection on the hat and edge. The rotor is developed from DuraGo’s two decades of brake component experience and is intended to meet fit, form, and function requirements for the specified Jeep applications.