Dynamic Friction 331-03612 Disc Brake Caliper - Rear Right

Overview

The Dynamic Friction 331-03612 is a disc brake caliper for rear right applications on select Hyundai Elantra models. It is part of the DFC Premium Caliper - Silver Zinc Coated line, which focuses on corrosion-resistant finish and direct replacement service for brake hydraulic repairs.

Key Features

• Disc brake caliper for brake hydraulic service
• Silver zinc coated finish for added corrosion resistance
• Rear right fitment for select Hyundai Elantra models
• Direct replacement format for brake system restoration
• Dynamic Friction part number 331-03612

Detailed Description

This Dynamic Friction brake caliper is built for 2017-2020 Hyundai Elantra rear right applications with rear disc brakes. The DFC Premium Caliper - Silver Zinc Coated line is intended for buyers who want a replacement caliper with a protective finish that helps resist surface corrosion in everyday driving conditions. If you are replacing a worn, sticking, or leaking caliper on a Hyundai Elantra, part number 331-03612 provides a focused fitment match for the listed application.

The 331-03612 caliper is a practical choice for brake service when the original caliper body or hydraulic function has degraded. It is listed for the rear right position only, so fitment should be matched carefully to the vehicle and brake configuration before installation. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Fix

• Brake drag caused by a sticking caliper piston or slide function
• Uneven rear braking from a worn hydraulic caliper assembly
• Fluid leakage at the caliper body or seal area
• Corrosion-related caliper wear on a rear disc brake setup
• Poor brake pedal response linked to caliper failure

Installation Notes

Confirm rear right placement and rear disc brake configuration before ordering. Inspect brake pads, rotor condition, and hydraulic lines during caliper replacement so the repaired system operates correctly. Bleeding the brake system after installation is required to remove air from the hydraulic circuit.

Quality Assurance

Dynamic Friction’s DFC Premium Caliper line uses a silver zinc coated finish to support corrosion resistance in brake service applications. Verify part number 331-03612 against the vehicle’s brake setup and existing caliper before installation.