Dynamic Friction 4514-54098 Disc Brake Kit - Front and Rear

Brake Kit for Ford F-150 and Lincoln Mark LT

The Dynamic Friction DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Ceramic and Hardware kit is built for front and rear brake service on select 2010-2011 Ford F-150 and 2010-2011 Lincoln Mark LT applications. Part number 4514-54098 combines coated rotors, ceramic pads, and matched brake hardware in one service kit for a complete brake refresh.

• Disc brake kit for front and rear service
• DFC GEOSPEC coated rotors with corrosion-resistant silver-gray finish
• 5000 Advanced ceramic brake pads with post-cured friction material
• Scorched pads for reduced initial bed-in time
• Premium rubber-steel-rubber shims for improved NVH control
• Non-directional rotor finish for smoother pad bedding
• OE-style hardware kit with PTFE coating, vulcanized rubber, and stainless steel
• Part number 4514-54098

Product Line Details

DFC Complete Brake Kits are organized to simplify brake service by combining the rotor, pad, and hardware components needed for a single axle or full vehicle brake job. The GEOSPEC rotor line uses dry, ready-to-install coated rotors that are machined to OE specifications, while the 5000 Advanced pad line focuses on stable friction performance, reduced break-in time, and quieter operation. Together, these components are aimed at consistent braking performance on vehicles such as the Ford F-150 and Lincoln Mark LT.

Fitment and Application

• Fits 2010-2011 Ford F-150, front and rear, 6 lug wheels, compatible with drum brake hardware kits.
• Fits 2010-2011 Lincoln Mark LT, front and rear, Mexico only.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Service Issues

• Brake noise from worn or fatigued hardware
• Uneven pad wear caused by reduced spring tension
• Rust buildup on uncoated rotors
• Longer stopping response from worn friction material
• Vibration or harshness during braking

Installation Notes

Inspect calipers, slides, and hub surfaces before installation. Clean the rotor mounting surface thoroughly and follow the vehicle service procedure for torque values and bedding instructions. The rotors are shipped dry and ready to install, which helps reduce prep time during brake service. Verify wheel configuration and application notes before ordering.

Quality Assurance

DFC GEOSPEC rotors are machined to tight tolerances, finished with a non-directional surface, and inspected for critical dimensions and balance. The rotors carry a 12-month warranty against defects in material and workmanship.