Dynamic Friction 600-03017 Disc Brake Rotor - Rear

Rear Brake Rotor for Hyundai Tiburon

The Dynamic Friction DFC Brake Rotor 600-03017 is a solid rear disc brake rotor built for 2003-2008 Hyundai Tiburon applications. It is sized to match the rear brake setup with an outside diameter of 258 mm, a nominal thickness of 10 mm, and a discard thickness of 8 mm.

Key Features

• Part number 600-03017 from Dynamic Friction
• DFC Brake Rotor product line
• Solid rear disc brake rotor design
• Outside diameter: 258 mm
• Nominal thickness: 10 mm
• Discard thickness: 8 mm
• Height: 45.3 mm
• Inside diameter: 76 mm
• 5-bolt hole pattern with 12.5 mm bolt hole diameter

Detailed Description

This rear brake rotor is engineered for Hyundai Tiburon rear brake service and matches the listed dimensional specifications for proper rotor replacement. The solid rotor construction is suited to rear axle applications where a non-vented design is specified, and the measured dimensions help support correct fitment on 2003-2008 Hyundai Tiburon models. If you are sourcing a rear brake rotor for Hyundai Tiburon 2003-2008, part number 600-03017 provides the key sizing details needed for a direct replacement search.

The DFC Brake Rotor line from Dynamic Friction focuses on application-specific brake components, and this rotor follows the exact rear fitment listed for the Tiburon. Use the part number 600-03017 when verifying catalog matchups, comparing brake rotor dimensions, or confirming a rear disc brake rotor replacement for Hyundai Tiburon service.

Common Reasons for Replacement

• Rear brake pulsation or vibration during braking
• Rotor wear that has reached discard thickness
• Brake noise caused by uneven rotor surfaces
• Reduced braking consistency from an out-of-spec rear rotor
• Need for a direct-fit rear rotor replacement on a Hyundai Tiburon

Installation Notes and Tips

Confirm rear fitment by matching the vehicle year, model, and rotor dimensions before installation. Verify the 5-bolt pattern, 258 mm outside diameter, 76 mm inside diameter, and 45.3 mm height against the existing rotor and hub setup. For best results, inspect pads, caliper condition, and hub mounting surfaces during rotor replacement, and follow the vehicle service manual for torque and bedding procedures.

Quality Assurance

Manufactured under the Dynamic Friction DFC Brake Rotor product line, this rotor is built to the listed dimensional specifications for the confirmed Hyundai Tiburon rear application. Part number 600-03017 should be matched against the vehicle catalog and brake measurements before installation.