Dynamic Friction 600-27000 Disc Brake Rotor - Front

Dynamic Friction DFC Brake Rotor 600-27000

The Dynamic Friction DFC Brake Rotor 600-27000 is a solid disc brake rotor built around precise dimensional specs for consistent brake service. With a 272.5 mm outside diameter, 69 mm height, and 5-bolt pattern, it is a direct-fit style rotor for applications that call for this exact configuration.

Key Features

• Part number 600-27000 from Dynamic Friction DFC Brake Rotor line
• Solid disc brake rotor construction
• Outside diameter: 272.5 mm
• Height: 69 mm
• Inside diameter: 68 mm
• Bolt hole quantity: 5
• Bolt hole diameter: 16.5 mm
• Nominal thickness: 12.7 mm
• Discard thickness: 11.4 mm

Product Details

The DFC Brake Rotor line focuses on application-specific brake rotor dimensions for service work that requires accurate fit and stable braking surface geometry. This solid rotor uses a 12.7 mm nominal thickness and 11.4 mm discard thickness, helping technicians verify wear limits during brake inspection. The 272.5 mm outside diameter and 69 mm overall height are important reference points when matching the rotor to the correct brake system. For Honda Civic and Toyota Corolla service, part number 600-27000 should be matched to the exact rotor dimensions and vehicle brake setup.

Compatible With select Honda Civic and Toyota Corolla brake applications where the listed rotor dimensions and 5-bolt pattern match the original equipment specification. Part number 600-27000 is also a useful reference when cross-checking Honda Civic and Toyota Corolla rotor service requirements against the vehicle’s brake system measurements.

What It Helps Address

• Brake pulsation caused by a worn or uneven rotor surface
• Reduced braking consistency from rotor thickness loss
• Rotor replacement needs during brake pad service
• Noise or vibration linked to rotor wear or distortion
• Measurement mismatch when replacing a solid rear or front rotor by specification

Installation Notes and Tips

Confirm outside diameter, height, bolt hole diameter, and bolt count before installation. Measure rotor thickness and compare it to the discard thickness of 11.4 mm to determine serviceability. Clean the hub mounting surface before installing the rotor, and verify that the brake pads, caliper, and wheel hardware match the vehicle’s original brake configuration. For Honda Civic and Toyota Corolla applications, always compare the rotor dimensions to the removed part before final assembly.

Quality Assurance

Dynamic Friction supplies the DFC Brake Rotor line as a dimension-specific brake component for service applications that require accurate rotor sizing and consistent fit verification. Part number 600-27000 should be selected by matching the listed measurements to the vehicle’s brake system requirements.