Dynamic Friction 600-27014 Disc Brake Rotor - Rear

DFC Brake Rotor for Volvo Rear Applications

The Dynamic Friction DFC Brake Rotor, part number 600-27014, is a solid rear disc brake rotor built for specific Volvo rear brake applications. It is sized for 5-bolt mounting and matches the dimensional requirements listed for compatible Volvo 740, 760, 780, 940, and 960 models.

Key Features

• Solid rear disc brake rotor construction
• Outside diameter: 265 mm
• Nominal thickness: 10 mm
• Discard thickness: 8 mm
• Inside diameter: 68 mm
• Bolt hole quantity: 5
• Bolt hole diameter: 15.6 mm
• Height: 53 mm
• DFC Brake Rotor line from Dynamic Friction

Detailed Description

The DFC Brake Rotor line focuses on direct-fit brake service parts with the dimensions needed for proper rotor replacement. This rear solid rotor is specified with a 265 mm outside diameter, 10 mm nominal thickness, and 8 mm discard thickness, making it a precise match for the listed Volvo rear brake setups. Part number 600-27014 is used on 1991-1994 Volvo 940 rear applications with independent rear suspension, 1992-1994 Volvo 960 rear applications with independent rear suspension, and rear brake configurations on Volvo 740, 760, and 780 models with the noted caliper combinations. For shoppers searching for a Volvo 940 rear brake rotor, Volvo 960 rear disc brake rotor, or Volvo 740 rear rotor replacement, this part number 600-27014 provides the fitment details needed to verify application before service.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Rear brake rotor wear that has reached discard thickness
• Brake pulsation caused by rotor thickness variation or surface wear
• Reduced braking consistency from an out-of-spec rear rotor
• Noise or vibration traced to a worn rear disc brake rotor
• Service replacement needs on listed Volvo rear brake systems

Installation Notes and Tips

• Verify rear axle and caliper configuration before ordering, especially on Volvo 740, 760, and 780 models.
• Confirm rotor dimensions against the existing part: 265 mm outside diameter, 10 mm nominal thickness, and 53 mm height.
• Inspect pads, caliper hardware, and hub condition during rotor replacement to support even braking performance.
• Clean the hub mounting surface before installation to reduce runout concerns.
• Use the vehicle-specific fitment notes for 1991-1994 Volvo 940, 1992-1994 Volvo 960, and 1988-1991 Volvo 740/760/780 rear applications.

Quality Assurance

Dynamic Friction DFC Brake Rotor components are cataloged with application-specific dimensions and fitment notes to support accurate brake service selection. Part number 600-27014 is identified for the listed Volvo rear brake applications, including 740, 760, 780, 940, and 960 models.