Dynamic Friction 600-54211 Disc Brake Rotor - Front

Dynamic Friction DFC Brake Rotor for Ford E-350 Super Duty

The Dynamic Friction DFC Brake Rotor, part number 600-54211, is a front vented disc brake rotor built for Ford E-350 Super Duty dual rear wheel applications. With a 345 mm outside diameter, 40 mm nominal thickness, and 38.4 mm discard thickness, it is specified for vehicles that need a direct-fit front rotor with the correct dimensions for consistent braking performance.

Compatible With 2008-2026 Ford E-350 Super Duty, front, including DRW configurations. This rotor is also a fitment match for 2021-2022 Ford E-350 Super Duty, front, for vehicles with dual rear wheels. The DFC Brake Rotor line focuses on application-specific brake rotor sizing and construction for service replacement use.

Key Features

• Part number 600-54211 for front brake service
• Vented disc brake rotor design
• 345 mm outside diameter for Ford E-350 Super Duty fitment
• 40 mm nominal thickness and 38.4 mm discard thickness
• 8-bolt hole pattern with 15.4 mm bolt hole diameter
• 123.8 mm inside diameter and 204 mm height
• Specified for front axle use on dual rear wheel vans

Detailed Description

This Dynamic Friction DFC Brake Rotor is engineered for the front position on Ford E-350 Super Duty models with dual rear wheels. The vented rotor construction supports heat management during repeated stops, while the listed dimensions help ensure proper rotor fitment and brake system alignment. If you are searching for a Ford E-350 Super Duty front brake rotor, part number 600-54211 provides the dimensional match needed for service replacement on the listed applications.

Use this rotor when replacing worn front rotors on 2008-2026 Ford E-350 Super Duty DRW vehicles. The DFC Brake Rotor designation identifies it as part of Dynamic Friction’s rotor line for brake maintenance where exact sizing matters.

What It Helps Address

• Brake pulsation caused by rotor wear or thickness variation
• Reduced braking consistency from a worn front rotor
• Rotor replacement needs on Ford E-350 Super Duty DRW front applications
• Noise or vibration associated with damaged or out-of-spec rotors
• Service intervals requiring a direct-fit vented front disc rotor

Installation Notes and Tips

Confirm the vehicle is a Ford E-350 Super Duty with dual rear wheels and verify front-position fitment before installation. Compare the existing rotor dimensions, bolt pattern, and hub interface to the specifications listed for part number 600-54211. Clean the hub mounting surface thoroughly and inspect related brake components for wear before completing the brake service.

Quality Assurance

Dynamic Friction supplies application-specific brake components under the DFC Brake Rotor line, with fitment and dimensional specifications provided for the listed Ford E-350 Super Duty front applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.