Dynamic Friction 631-27019R Disc Brake Rotor - Rear Right

Overview

The Dynamic Friction 631-27019R is a rear right disc brake rotor for select Volvo applications. It combines a slotted and drilled surface with a zinc silver hat finish and rust-resistant coating for a clean, service-ready appearance.

Compatible with Volvo C70, S70, V70, and 850 applications listed below, this rotor is built around the specified 295 mm outside diameter and 5-lug, 108 mm bolt pattern. The 631-27019R is a fitment-specific replacement for drivers looking for a direct rotor match on the rear right side.

Key Features

• Slotted and drilled brake surface for consistent pad contact and heat management.
• Zinc silver hat finish with rust-resistant coating for added corrosion protection.
• Solid rotor design with a 295 mm outside diameter.
• 5-lug construction with 108 mm bolt circle and 14.75 mm bolt holes.
• Directional brake surface for application-specific installation.

Detailed Description

Dynamic Friction 631-27019R is a disc brake rotor engineered for rear right fitment on select Volvo C70, S70, V70, and 850 models. The slotted X-drilled surface is paired with a plain disc finish and a zinc silver hat finish, giving the rotor a functional design with corrosion resistance where it matters most. The solid rotor construction, 72 mm overall height, and 68 mm center hole diameter match the listed application requirements.

This part number, 631-27019R, is specified for vehicles with the fitment notes shown in the application table, including C70 and S70 models with 280 mm or 302 mm front rotors. If you are replacing a worn rear right rotor on a Volvo C70, Volvo S70, or Volvo V70, this rotor provides the dimensions and surface design needed for the listed applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake pulsation caused by uneven rotor wear.
• Reduced braking consistency from a worn rear rotor surface.
• Surface corrosion on the rotor hat and exposed metal areas.
• Fitment issues from incorrect bolt pattern or center bore dimensions.
• Noise or pad contact problems related to an out-of-spec rotor surface.

Installation Notes and Tips

Verify the rear right position and match the vehicle notes before ordering. Confirm the 5-lug, 108 mm bolt circle, 68 mm center hole, and listed rotor dimensions against the existing part. Because the brake surface is directional, install it according to the application-specific orientation.

Quality Assurance

Dynamic Friction supplies brake components with application-specific engineering and corrosion-resistant finishes for service replacement use. Confirm all fitment details for the Volvo C70, S70, V70, or 850 before installation.