Dynamic Friction 631-67010R Disc Brake Rotor - Rear Right

Drilled and Slotted Rear Right Brake Rotor

The Dynamic Friction DFC Brake Rotor - Drilled and Slotted - Silver, part number 631-67010R, is a rear right disc brake rotor built for specific Nissan applications. It features a slotted X drilled surface, zinc silver hat finish, and a rust resistant coating for service in demanding brake environments.

Key Features

• Part number 631-67010R for direct reference
• Slotted X drilled rotor surface for consistent pad contact
• Rust resistant coating helps protect the rotor finish
• Zinc silver hat finish for a clean, corrosion-resistant appearance
• Solid rotor design with 269 mm outside diameter
• Directional brake surface for correct installation orientation
• 4-bolt, 4-lug pattern with 114.3 mm bolt circle diameter
• 68 mm center hole diameter and 12.75 mm stud/lug hole diameter

Product Details

This DFC Brake Rotor - Drilled and Slotted - Silver is engineered for rear right placement on select Nissan 200SX, Nissan 280ZX, and Nissan Maxima models. The rotor measures 269 mm in outside diameter, 68.5 mm in overall height, and uses an 8.6 mm discard thickness with a 9.6 mm nominal thickness. The plain disc finish and directional slotted-and-drilled surface support stable braking performance while the rust resistant coating helps preserve the rotor during everyday use. Part number 631-67010R is a fitment-specific rotor for Nissan rear brake service.

Vehicle Fitment

• Fits 1980-1981 Nissan 200SX, rear right.
• Fits 1979-1981 Nissan 280ZX, rear right.
• Fits 1981 Nissan Maxima, rear right, from 8/81.
• Fits 1981 Nissan Maxima, rear right, to 7/81.

Common Reasons for Replacement

• Rear brake rotor wear beyond discard thickness
• Brake pulsation from rotor surface irregularity
• Corrosion on the braking surface or hat area
• Reduced braking consistency during repeated stops
• Noise or vibration traced to rotor condition

Installation Notes and Tips

Confirm rear right position, bolt circle diameter, center hole diameter, and lug hole dimensions before installation. Because this rotor uses a directional brake surface, install it in the correct orientation for the vehicle side. Verify rotor thickness against the discard thickness specification and inspect pads, caliper condition, and hub surfaces during brake service. For search reference, this rotor is commonly sought for Nissan 200SX rear right brake repair, Nissan 280ZX rear right brake replacement, and 1981 Nissan Maxima rear right rotor service. Part number 631-67010R may also be listed as 63167010R in catalog searches.

Quality Assurance

Dynamic Friction DFC brake rotors are cataloged with application-specific dimensions and finish details to support accurate parts selection. This rotor is identified by part number 631-67010R and is specified for the listed Nissan rear right applications.