Dynamic Friction 631-76175R Disc Brake Rotor - Front Right

Front Right Drilled and Slotted Rotor

The Dynamic Friction DFC Brake Rotor - Drilled and Slotted - Silver, part number 631-76175R, is a vented disc brake rotor built for the front right position. It features a slotted X drilled surface, a 340 mm outside diameter, and a 32 mm nominal thickness with 29 mm discard thickness for service planning.

Compatible With 2024-2026 Toyota Tacoma, front right; 2024-2026 Toyota Land Cruiser, front right; and 2025-2026 Toyota 4Runner, front right. The directional braking surface and silver finish support a clean, application-specific replacement for these Toyota front brake setups.

Key Features

• Part number 631-76175R for front right brake rotor replacement
• Slotted X drilled surface type for a performance-oriented rotor design
• Vented rotor construction for front axle heat management
• 340 mm outside diameter with 83.6 mm height
• 6-bolt pattern with 6 lug holes
• 97 mm center hole diameter and 139.7 mm bolt circle diameter
• Directional brake surface for correct rotation-specific installation
• Silver finish with plain disc finish specification

Product Details

This DFC Brake Rotor - Drilled and Slotted - Silver is engineered around the listed dimensions and fitment requirements for Toyota Tacoma, Toyota Land Cruiser, and Toyota 4Runner front right applications. The vented design, directional surface, and drilled-and-slotted pattern are specified to match the braking geometry of these vehicles while maintaining the correct rotor size and mounting layout. Part number 631-76175R should be matched to the exact front right position and vehicle configuration shown in the fitment data.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake pulsation caused by rotor wear or uneven surface condition
• Reduced braking consistency from an out-of-spec front rotor
• Heat buildup in front brake service conditions
• Noise or vibration associated with worn rotor surfaces
• Replacement needs for the front right rotor on listed Toyota models

Installation Notes

Install only on the confirmed front right position and verify the rotor matches the vehicle’s bolt pattern, center bore, diameter, and thickness specifications before service. Because the brake surface is directional, confirm rotation orientation during installation. Always inspect pads, caliper condition, and hub mounting surfaces during brake work to help ensure proper rotor seating.

Quality Assurance

Dynamic Friction supplies this rotor as a specification-based brake component with defined dimensions, finish, and fitment for the listed Toyota applications. The part number 631-76175R is tied to the exact rotor configuration shown above for accurate ordering and service matching.