Dynamic Friction 633-54282R Disc Brake Rotor - Rear Right

Overview

This Dynamic Friction disc brake rotor is built for the rear right position on compatible Ford Mustang Mach-E applications. It uses a slotted and drilled surface with a black zinc hat finish and rust-resistant coating for a clean, service-ready appearance.

Part number 633-54282R is a fitment-specific rotor for 2021-2025 Ford Mustang Mach-E models. The directional brake surface and plain disc finish support consistent braking performance in the intended application.

Key Features

• Slotted X drilled rotor surface for improved pad bite and heat management.
• Zinc black hat finish with rust-resistant coating for added corrosion protection.
• Directional brake surface for application-specific braking geometry.
• 5-lug bolt pattern with 108 mm bolt circle diameter.
• OE-style rotor dimensions for direct replacement use.

Detailed Description

The Dynamic Friction 633-54282R is a rear right disc brake rotor engineered for 2021-2025 Ford Mustang Mach-E fitment. Its 316 mm outside diameter, 11 mm nominal thickness, and 9 mm discard thickness provide the dimensional profile needed for the specified application. The slotted and drilled surface helps maintain rotor surface consistency under braking, while the black zinc hat finish and rust-resistant coating help protect exposed areas from corrosion.

Use part number 633-54282R when replacing a worn or damaged rear right rotor on a Ford Mustang Mach-E. This rotor is also identified by the same part number 633-54282R for ordering and fitment verification.

What It Is Used For

• Replacing a worn rear right brake rotor.
• Correcting brake pulsation caused by rotor wear or surface irregularity.
• Restoring braking contact surface after scoring or heat checking.
• Addressing corrosion on the rotor hat or braking surface.

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and rear right fitment before installation. Clean the hub mounting surface and inspect pads, caliper hardware, and wheel bearings for wear before installing the new rotor. Confirm that the directional surface orientation matches the intended side of the vehicle.

Quality Assurance

Dynamic Friction supplies brake components with application-specific dimensions and corrosion-resistant finishes for service replacement use. Part number 633-54282R is built to match the listed fitment and rotor specifications.