Dynamic Friction 633-67029R Disc Brake Rotor - Rear Right

Overview

This Dynamic Friction disc brake rotor is built for rear right fitment on select Nissan 240SX applications. The DFC Brake Rotor - Drilled and Slotted - Black part number 633-67029R combines a directional slotted and drilled surface with a black zinc hat finish for a clean, corrosion-resistant appearance.

Compatible With Nissan 240SX rear right applications, this rotor is a direct-fit replacement for vehicles that require a 4-lug rear rotor with the listed dimensions and bolt pattern. Part number 633-67029R is also identified by the same application-specific fitment details across the supported model years.

Key Features

• Slotted and drilled braking surface for consistent pad contact and heat management.
• Black zinc hat finish with rust-resistant coating for added corrosion protection.
• Solid rotor design with directional surface pattern.
• 4-bolt, 4-lug configuration with 114.3 mm bolt circle.
• Built to match the specified outside diameter, center hole, and height requirements.

Detailed Description

The Dynamic Friction 633-67029R is a disc brake rotor engineered around the fitment and dimensional requirements of select Nissan 240SX rear right applications. Its slotted X drilled surface and directional braking face are intended to maintain stable pad engagement, while the plain disc finish and black hat finish provide a practical balance of function and appearance. The rotor’s 4-lug layout, 114.3 mm bolt circle, and listed center hole diameter support the exacting fit needed for the covered vehicles. If you are replacing a worn rear rotor on a Nissan 240SX, this part number 633-67029R gives you a fitment-specific option with the correct hardware geometry and surface design.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake pulsation caused by uneven rotor wear.
• Reduced braking consistency from heat buildup.
• Corrosion on exposed rotor surfaces and hat areas.
• Fitment issues on 4-lug rear rotor applications.
• Noise or pad contact problems related to worn braking surfaces.

Installation Notes

Verify rear right fitment, 4-lug wheel compatibility, and the 1996 production-date split before installation. The 1996 Nissan 240SX uses separate fitment based on production date, so confirm whether the vehicle was built before or after 7/96. Match the rotor dimensions, bolt circle, and center hole diameter to the existing application before service.

Quality Assurance

Dynamic Friction supplies this rotor as a fitment-specific replacement under the DFC Brake Rotor - Drilled and Slotted - Black line. Part number 633-67029R is built to the listed specifications for the covered Nissan 240SX applications.