Dynamic Friction 633-67056R Disc Brake Rotor - Front Right

Drilled and Slotted Front Right Rotor

The Dynamic Friction DFC Brake Rotor - Drilled and Slotted - Black, part number 633-67056R, is a vented disc brake rotor built for the front right position. It features a slotted X drilled surface, a zinc black hat finish, and a rust resistant coating for added surface protection.

Compatible with select Nissan Cube, Nissan Sentra, and Nissan Versa front right applications, this rotor is sized with a 280 mm outside diameter, 68 mm center hole diameter, and 114.3 mm bolt circle diameter. The directional brake surface is engineered for the specified application and the plain disc finish keeps the braking surface straightforward and functional.

Key Features

• Part number 633-67056R
• Drilled and slotted vented disc brake rotor
• Front right position fitment
• Zinc black hat finish with rust resistant coating
• 280 mm outside diameter
• 68 mm center hole diameter
• 4-bolt, 4-lug pattern with 114.3 mm bolt circle diameter
• Directional brake surface for the listed application

Product Details

The DFC Brake Rotor - Drilled and Slotted - Black line from Dynamic Friction focuses on rotor construction and surface design for vehicles that use a vented front rotor. This 633-67056R rotor uses a slotted X drilled surface to support consistent pad contact characteristics, while the black zinc hat finish helps protect the hat area from corrosion. It is listed for 2007-2012 Nissan Sentra front right, 2007-2012 Nissan Versa front right, and 2009-2014 Nissan Cube front right applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Replacement Reasons

• Front rotor wear that has reached discard thickness
• Brake pulsation from rotor surface variation
• Visible rust on the rotor hat area
• Reduced braking consistency from an uneven rotor surface
• Need for a direct replacement rotor for Nissan Cube, Sentra, or Versa front right service

Installation Notes

Verify rotor dimensions, bolt pattern, and front right position before installation. Confirm the vehicle uses a 4-lug, 114.3 mm bolt circle application and check discard thickness against the existing rotor before replacement. Always inspect pads, caliper condition, and hub mating surfaces during brake service.

Quality Assurance

Dynamic Friction identifies this rotor with a rust resistant coating and zinc black hat finish for corrosion protection on the non-friction surfaces. The directional, vented, drilled, and slotted design is specified for the listed Nissan applications and should be matched to the vehicle’s brake system requirements.