Dynamic Friction 830-59050R Disc Brake Rotor - Rear Right

Overview

The Dynamic Friction 830-59050R is a rear right disc brake rotor for select Honda Odyssey applications. It combines a slotted and drilled surface with a rust-resistant coating and a Geospec silver gray hat finish for a clean, service-focused replacement.

Fits 2005-2010 Honda Odyssey, rear right. This rotor is built around a 313 mm outside diameter, 5-lug bolt pattern, and directional braking surface for the specified application.

Key Features

• Slotted and drilled rotor surface for consistent pad contact and heat management.
• Rust-resistant coating helps protect exposed surfaces from corrosion.
• Geospec silver gray hat finish provides a finished appearance on the hub area.
• Solid rotor design with 11 mm nominal thickness and 9 mm discard thickness.
• 5-bolt, 5-lug pattern with 120 mm bolt circle diameter.

Detailed Description

Dynamic Friction 830-59050R is a disc brake rotor engineered for the rear right position on 2005-2010 Honda Odyssey models. The directional slotted and drilled braking surface is paired with a plain disc finish and a rust-resistant coating to support stable braking performance and long-term surface protection. The rotor measures 313 mm in outside diameter, with a 70.1 mm center hole diameter and 63.6 mm overall height.

As part of the DFC Geoperformance Rotor - Drilled and Slotted line, this rotor focuses on surface design and corrosion protection rather than cosmetic extras. It is a fitment-specific replacement for Honda Odyssey brake service where the correct rear right rotor dimensions and lug pattern are required. The part number 830-59050R is also useful when verifying the exact application during brake maintenance.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake pulsation related to worn or uneven rotor surfaces.
• Surface corrosion on exposed braking components.
• Reduced braking consistency from heat-affected rotor faces.
• Fitment issues when replacing a rear right rotor on the specified vehicle.

Installation Notes

Confirm the rear right position, 5-lug bolt pattern, 120 mm bolt circle diameter, and 313 mm outside diameter before installation. Verify discard thickness, nominal thickness, and center hole diameter against the removed rotor to ensure correct fitment. The directional surface must be installed in the proper orientation for the application.

Quality Assurance

Dynamic Friction supplies this rotor under the DFC Geoperformance Rotor - Drilled and Slotted line, which emphasizes application-specific dimensions, corrosion protection, and surface design for brake service.