Dynamic Friction 830-72071R Disc Brake Rotor - Rear Right

Overview

The Dynamic Friction 830-72071R is a rear right disc brake rotor built for vehicles that use a 5-lug, 114.3 mm bolt circle and a directional slotted-and-drilled surface. It is a fitment-specific rotor for select Mitsubishi, Nissan, and INFINITI applications, including the Outlander, Pathfinder, and QX60.

As part of the DFC Geoperformance Rotor - Drilled and Slotted line, this rotor combines a plain disc finish with a Geospec silver gray hat finish and rust-resistant coating for added surface protection.

Key Features

• Directional slotted and drilled braking surface for consistent pad contact and heat management.
• Rust-resistant coating helps protect exposed surfaces from corrosion.
• Geospec silver gray hat finish for a clean, finished appearance.
• 5-bolt, 5-lug design with a 114.3 mm bolt circle and 68 mm center hole.
• Fits rear right applications on select Mitsubishi, Nissan, and INFINITI models.

Detailed Description

The 830-72071R is engineered as a direct-fit disc brake rotor for specific rear right applications on the Mitsubishi Outlander, Nissan Murano, Nissan Pathfinder, INFINITI QX60, Mitsubishi Outlander PHEV, Nissan ARIYA, and Nissan X-Trail. Its directional slotted X drilled surface is intended to maintain a stable braking interface while supporting heat dissipation under repeated stops. The rotor measures 330 mm in outside diameter, 47.5 mm in height, and uses a 68 mm center hole with 5 bolt holes.

This DFC Geoperformance Rotor - Drilled and Slotted part number 830-72071R is a practical replacement when the original rotor shows wear, surface corrosion, or braking vibration. The plain disc finish and rust-resistant coating help preserve the rotor surface, while the directional design supports consistent operation in the specified rear right position. For buyers searching for a Mitsubishi Outlander rear right brake rotor or a Nissan Pathfinder rear right disc brake rotor, 830-72071R provides a fitment-matched option.

Common Replacement Needs

• Brake pulsation caused by rotor wear or uneven surface condition.
• Visible rust or corrosion on the braking surface or hat area.
• Reduced braking consistency from a worn rear rotor.
• Noise or vibration during braking from an out-of-spec rotor.

Installation Notes

Verify rotor dimensions, bolt pattern, and rear right fitment before installation. Confirm that the vehicle uses a 330 mm rotor with a 114.3 mm bolt circle and 68 mm center hole. Because this rotor is directional, install it in the correct orientation for the specified application. Always inspect pads and related brake components during rotor replacement.

Quality Assurance

Dynamic Friction’s DFC Geoperformance Rotor line is built around application-specific brake rotor design and corrosion protection features. Part number 830-72071R is made to match the listed fitment and dimensional requirements for the specified vehicles.