Dynamite Friction 341-31032 Disc Brake Pad Wear Sensor - Rear

Rear Brake Pad Wear Sensor Wire for BMW

Dynamite Friction 341-31032 is a rear disc brake pad wear sensor wire for select BMW applications. It provides the direct-fit sensor connection needed for brake wear monitoring on 2006-2010 BMW 530xi, 535xi, and 535i xDrive rear brake setups.

Key Features

• Disc brake pad wear sensor wire for rear brake service
• Fits 2006-2007 BMW 530xi, rear
• Fits 2008 BMW 535xi, rear
• Fits 2009-2010 BMW 535i xDrive, rear
• Part number 341-31032 for easy identification

Product Details

This Dynamite Friction Sensor Wire is built for vehicles equipped with electronic brake pad wear monitoring. When the brake pads wear down, the sensor wire completes the circuit and triggers the warning system, helping maintain accurate brake service alerts. For BMW 530xi rear brake sensor wire replacement, BMW 535xi rear brake sensor wire replacement, or BMW 535i xDrive rear brake wear sensor service, 341-31032 matches the listed rear applications.

Common Issues It Can Address

• Brake wear warning light stays on after pad service
• Damaged or broken rear pad wear sensor wire
• Incorrect brake wear signal after brake pad replacement
• Need for a direct-fit rear sensor wire on listed BMW models

Installation Notes

Install on the rear brake position only for the listed BMW models and years. Inspect the sensor routing and connector condition before installation, and replace any worn or damaged retaining points during brake service. Verify the part number 341-31032 against the vehicle application before installation.

Quality Assurance

Dynamite Friction 341-31032 is a brake sensor component from the Sensor Wire product line, built for the specified BMW rear brake applications.