Dynamite Friction 341-73000 Disc Brake Pad Wear Sensor - Front

Disc Brake Pad Wear Sensor for Audi Front Brakes

Dynamite Friction 341-73000 is a front disc brake pad wear sensor wire for select Audi applications with ATE or Girling brakes. It provides direct wear-sensor replacement coverage for 1989-1991 Audi 200 and 200 Quattro models, plus the 1989 Audi 100 Quattro.

Key Features

• Front disc brake pad wear sensor wire
• Brand Line: Sensor Wire
• Direct fit for select Audi front brake applications
• Supports ATE brake and Girling brake configurations where listed
• Part number 341-73000 for catalog lookup and ordering

Detailed Description

Dynamite Friction 341-73000 is a brake wear sensor wire used at the front axle to monitor pad wear on listed Audi vehicles. This part is cataloged for 1989-1991 Audi 200, front, with ATE Brakes; Sensor Wire, 1989-1991 Audi 200, front, with Girling Brakes; Sensor Wire, 1989-1991 Audi 200 Quattro, front, with Girling Brakes; Sensor Wire, 1989-1991 Audi 200 Quattro, front, with ATE Brakes; Sensor Wire, and 1989 Audi 100 Quattro, front, with ATE Brakes; Sensor Wire. If you are replacing a worn or damaged front brake pad wear sensor on an Audi 200 or Audi 200 Quattro, 341-73000 matches the listed brake system and position requirements.

The Sensor Wire product line identifies this as a dedicated wear-sensor component rather than a general-purpose brake part. Use 341-73000 when the vehicle calls for a front pad wear sensor wire on the specified Audi brake setup.

What It Is Used For

• Brake warning light stays on after pad service
• Broken, frayed, or disconnected front wear sensor wire
• Pad wear monitoring fault on listed Audi front brake systems
• Replacement of a damaged sensor during brake pad maintenance

Installation Notes and Tips

Verify the brake system type before ordering: the listed fitment includes ATE and Girling front brake configurations. Confirm the vehicle year, model, and front position against the existing sensor connection and routing before installation. Part number 341-73000 should be matched to the original sensor wire layout on the vehicle.

Quality Assurance

Built under the Dynamite Friction Sensor Wire line for the listed Audi brake applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.