Dynamite Friction 355-76161 Brake Master Cylinder

Brake Master Cylinder for 2003 Toyota Sienna

This Dynamite Friction DFC Brake Master Cylinder is a direct-fit hydraulic replacement for the 2003 Toyota Sienna without Vehicle Stability Control. Part number 355-76161 is built for the brake system application listed below and supports proper master cylinder function in the vehicle’s hydraulic circuit.

Key Features

• Brake master cylinder for the DFC Brake Master Cylinder product line
• Fits 2003 Toyota Sienna, N/A
• Application note: does not fit vehicles with Vehicle Stability Control
• Part number 355-76161 for identification and ordering
• Category: Brake > Brake Hydraulics

Application Details

Compatible With 2003 Toyota Sienna brake hydraulic service where the vehicle is not equipped with Vehicle Stability Control. The DFC Brake Master Cylinder line is positioned as a dedicated brake hydraulics replacement option, and this unit is identified by part number 355-76161. If you are searching for a 2003 Toyota Sienna brake master cylinder or a 355-76161 replacement master cylinder, this listing matches the fitment shown in the catalog data.

Common Problems This Part May Address

• Brake pedal travel that feels inconsistent due to master cylinder wear
• Internal hydraulic leakage in the brake master cylinder
• Loss of brake pressure at the master cylinder
• Brake system service on a 2003 Toyota Sienna without Vehicle Stability Control

Installation Notes

Verify the vehicle is a 2003 Toyota Sienna and confirm it does not have Vehicle Stability Control before ordering. Inspect the brake hydraulic system, bench bleed the master cylinder if required by the service procedure, and bleed the brake system thoroughly after installation. Match the part number 355-76161 to the application before installation.

Quality Assurance

Dynamite Friction supplies this DFC Brake Master Cylinder as a cataloged brake hydraulics replacement part for the listed application. Fitment is limited to the vehicle shown in the product data.